User manual CHICAGO 90799

[. . . ] Read all instructions before using this product!When not in use, the Ramp must be stored in a dry location to inhibit damage from moisture and salt air. Before using any ramp, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for any broken or damaged ramps and any other conditions that may affect its operation. [. . . ] The Aluminum Bi-Fold Ramp can be used together as a Bi-Fold connected ramp, or can be used separately. To join the Bi-fold Ramp together and use it as one connected ramp, complete the following steps. Lay both Ramps (1) down on a large, flat area that is clear of debris. Line up the Ramps (1) so that the Hinges (3) are in position as shown in Figure 1. Place Hinge (3) so the Bolt (4) can be inserted through the center of both sides of the Hinge (3) and secure with Nut (5). Repeat for second Hinge (3). SKU 90799 Page 4. Once the Bolts (4) and Nut (5) secure the Hinges you are ready to use the Bi-fold Ramp as one connected Ramp. Make certain both Ramps are tight against one another and straight. Make certain that there are no gaps between Ramps. To separate the Bi-Fold Ramp, remove the Bolt (4) and Nut (5) in each Hinge (3). Then slide the Hinges (3) apart from each other. The Bi-Fold Ramp is now ready to be used as a set of two narrower Ramps. Operation When operating your Aluminum Bi-fold Ramp, refer to each of the operational Figures as well as to the Parts List and Assembly Diagram located on the last page of this manual. Warning!All persons not involved in the loading process must stand clear of the loading Ramp. Maximum (see page 2 Specifications Section). Make sure the vehicle which you are loading into is turned off and in gear or park, with the emergency brake engaged. Make sure the Ramp is completely open and the securing chains and hooks are correctly in place. Make sure the Ramp is clean and dry before loading. Step 1) Make certain that the tailgate the Ramp will sit on is dry and clean. Set the tongue of the Ramp on the tailgate. Stretch the Safety Chains and Hooks (2) on each side of the Ramp up into the inside of the truck bed. Attach both Safety Chains and Hooks (2) to a secure location on the inside of the truck bed. The Safety Chain and Hook (2) should be taut so that the Ramp's tongue can not slip off of the tailgate. Step 2) Very slowly, drive or push the vehicle that you wish to load so that the front tires are on the Ramp without moving the tongue resting on the tailgate. [. . . ] We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion may not apply to you. THIS WARRANTY IS ExPRESSLY IN LIEU OF ALL OTHER WARRANTIES, ExPRESS OR IMPLIED, INCLUDINg THE WARRANTIES OF MERCHANTABILITY AND FITNESS. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. [. . . ]