User manual CHICAGO 93019

[. . . ] TRANSMISSION FLUID OIL EXCHANGER 93019 SeT up anD OpeRaTing inSTRucTiOnS Distributed exclusively by Harbor Freight Tools®. 3491 Mission Oaks Blvd. , Camarillo, CA 93011 Visit our website at: http://www. harborfreight. com Read this material before using this product. Failure to do so can result in serious injury. SaVe THiS manual. Copyright© 2008 by Harbor Freight Tools®. [. . . ] Keep a type ABC fire extinguisher nearby in case of fire. When leaks are found in the equipment or hoses, immediately turn the air pressure off and repair the leaks. Keep an empty plastic bucket nearby in case of leaks. Immediately clean up any fluid spills or leaks. Do not exceed the recommended operating air pressure. This could damage equipment or create a hazardous situation. When cleaning, only use cleaning compounds made for use with transmissions. Empty all new and used fluid from the system, disconnect the air supply, and ensure that the system is not pressurized before changing the fluid filter or performing any other maintenance or repair procedures to the Transmission Oil Exchanger. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpacking When unpacking, check to make sure the following parts are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible. Fluid Exchanger System Assorted Fittings, Adapters, and Hoses in kit Spare Oil Filter 3 - Connection Hoses REV 08/05; 01/07 SKU 93019 For technical questions, please call 1-800-444-3353 Page 4 Controls and Indicators Air Input Used Oil View Flow New Oil View Flow Air Pressure Gauge Oil Fill Cap New Oil Input Hose Connector Oil Pressure Gauge Filling - Recycle Reverse Control Fuel Pressure Recycle Control Air Pressure Regulator Control Return Adapter Quick Connector Pressure Adapter Quick Connector Fill Gauge Fill Gauge Used Oil Tank New Oil Tank As the tanks are filled, the fluids can be viewed through the tank and measured. SKU 93019 For technical questions, please call 1-800-444-3353 Page 5 Operation Warning: The vehicle engine must never be started in a closed garage, or any other sealed structure. Carbon monoxide is produced during operation and is deadly in a closed environment. Early signs of carbon monoxide poisoning resemble the flu, with headaches, dizziness, or nausea. If you have any of these signs get fresh air immediately. Place vehicle on a hoist or on secure vehicle stands in a well ventilated area. Set vehicle emergency brake and turn engine off. Locate the hose connection points on the transmission and its radiator. Refer to the vehicle manufacturer's maintenance manual and adhere to all safety warnings and instructions in this manual. Place the Transmission Oil Exchanger (TOE) unit to one side of the vehicle. Turn on the air compressor (not supplied) and place its hose next to the TOE. Have new transmission fluid or cleaning solvent ready for use near the TOE. Filling Cleaning Fluids 1. Disconnect the transmission return line from under the transmission and from the automatic transmission cooler. Connect the TOE Black Hose (return line) to the oil outlet connector under the transmission. [. . . ] Adjust the air pressure, if necessary, to accommodate this. ) 8. Start the engine and view the oil flow through the TOE New and Used Oil View Flow tubes. When the color of the oil is the same in both tubes, the process is complete. During the oil transfer process, with your foot securely holding down the brake, switch gears in sequential order, starting with first gear. [. . . ]