User manual CHICAGO 93213

[. . . ] ELECTRIC CHAINSAW SHARPENER Model 93213 SET uP ANd OPERATINg INSTRuCTIONS Visit our website at: http://www. harborfreight. com Read this material before using this product. Failure to do so can result in serious injury. SAVE THIS MANuAL. Copyright© 2005 by Harbor Freight Tools®. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. [. . . ] Replacement grinding wheel listed speed must meet or exceed RPM rating of the tool. Use only flanges furnished with the tool. This machine is designed to sharpen chainsaw chains. Do not attempt to sharpen any other tools, and do not attempt to grind any other objects. 2. REV 09b For technical questions, please call 1-800-444-3353. SKU 93213 gROuNdINg TO PREVENT ELECTRIC SHOCK ANd dEATH FROM INCORRECT gROuNdINg WIRE CONNECTION: Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. do not modify the power cord plug provided with the tool. Never remove the grounding prong from the plug. do not use the tool if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician. 2. The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the tool. The green wire in the cord must be the only wire connected to the tool's grounding system and must never be attached to an electrically "live" terminal. (See 3-Prong Plug and Outlet. ) The tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the preceding illustration. (See 3-Prong Plug and Outlet. ) 3. double Insulated Tools: Tools with Two Prong Plugs grounded Tools: Tools with Three Prong Plugs Outlets for 2-Prong Plug 1. Tools marked "Double Insulated" do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc. , the Canadian Standard Association, and the National Electrical Code. (See Outlets for 2-Prong Plug. ) Double insulated tools may be used in either of the 120 volt outlets shown in the preceding illustration. (See Outlets for 2-Prong Plug. ) 3-Prong Plug and Outlet 1. Tools marked with "Grounding Required" have a three wire cord and three prong grounding plug. The plug must be connected to a properly grounded outlet. If the tool should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user, reducing the risk of electric shock. (See 3-Prong Plug and Outlet. ) 2. SKU 93213 For technical questions, please call 1-800-444-3353. Page 5 Extension Cords 1. Grounded tools require a three wire extension cord. [. . . ] Remember to turn off the machine and unplug it if you need to make any adjustments. After you repeat all of the steps under Sharpening on page 7, your chain is ready to be mounted on your saw. Page 12 For technical questions, please call 1-800-444-3353. SKU 93213 MAINTENANCE 1. Keep the Sharpener clean and free of dust, metal debris and dirt. Check the Grinding Wheel before each use to make sure it isn't damaged. [. . . ]