User manual CHICAGO 93645

[. . . ] Always wear ANSI approved safety goggles during use. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed. [. . . ] Read warning labels if taking prescription medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not use this tool. When servicing, use only identical replacement parts. Use of any other parts is dangerous and will void the warranty. Only use accessories intended for use with this tool. DO NOT USE ANY DIFFERENT HANDLES OR SOCKETS WITH THIS TOOL; sockets/handles not designed for this tool may break or cause the unit to become unstable, causing personal injury or property damage. This unit may cause some cosmetic damage to the rim during normal use. Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause you to lose control. Protect others in the work area from debris such as chips and sparks. The warnings, cautions, and instructions discussed in this instruction sheet cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this set, but must be supplied by the operator. 6. 7. SAVE THIS INSTRUCTION SHEET. (Operation on Back. ) Operation (Refer to the diagram to the right and the picture on the front. ) 1. Attach the chosen Socket (1a-1d) to the Output Driver (7). Note: The Output Driver (7) is on the side of the Housing (4) that has no screw heads visible. Attach the Support Socket and Knob (2, 3) through the slot in the housing, with the Support Socket (2) on the same side as the Socket (1a). [. . . ] Keep in mind that this device allows you to apply much more torque than you ordinarily could. After use, disassemble, clean, and store in Carrying Case (19). Parts List Part 1a 1b 1c 1d 2 3 4 5 Description 19mm Socket 3/4" Socket 13/16" Socket 7/8" Socket Suppor t Socket Suppor t Knob Housing Bearing Part 6 7 8 9 10 11 12 13 Description Outer Annulus Gear Output Driver Pin Inner Annulus Gear Eccentric Bushing Pin Inner Annulus Gear Input Driver PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. [. . . ]