User manual CHICAGO 93980

[. . . ] Always lock up tools and keep out of reach of children. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There are certain applications for which this tool was designed. It will do the job better and more safely at the rate for which it was intended. [. . . ] Do not operate tool if under the influence of alcohol or drugs. Read warning labels if taking prescription medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool. Always wear ANSI-approved eye protection during use. Product Specific Safety Precautions 1. Be certain that the separator jaws are evenly set between bearing halves before attempting to separate. Lead Screw (5) should be centered on the shaft where the bearings are being pulled to avoid damaging shaft or bearing housing. Avoid pinching or scraping the bearing shaft by securely (and squarely) placing the Jaws around the bearing housing. Use care when removing the Lead Screw (5) from the Case to avoid damaging the threads. Pry up from the ends of the Lead Screw. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpacking When unpacking, check to make sure that all the parts are included. Refer to the Parts Photo and Parts List at the end of this manual. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual. SKU 93980 For technical questions, please call 1-800-444-3353 Page 3 Operation Pulling Bearings off Shaft 1. Select the proper size Bearing Separator Jaw (2. 2"~3. 0" #2 or 2" #14) for the bearing size being removed from the shaft. Loosen the Separator Jaw Nuts (3) sufficiently to allow the jaws to catch behind the bearing housing. Using a wrench (not supplied) begin to (evenly) tighten the Nuts (3) until the jaws are securely set behind the bearing housing. Screw in both Extension Screws of the same length (5" - 4 and 12, or 4" - 6 and 9) into the Bearing Separator Jaws as shown below. Note: Do not use Extension Screws of different lengths. Place the 6 inch Yoke (16) over the Extension Screws and tightly secure with Washers (7) and Nuts (3). Screw in Lead Screw (5) into the Yoke (16) until it touches the center of the shaft where the bearings are mounted. Using a wrench, turn the Lead Screw (5) clockwise until the bearing housing begins to move off the shaft. Continue turning the Lead Screw until the bearing housing is off the shaft. Remove the Lead Screw (5) by turning it counterclockwise. [. . . ] This warranty does not apply to damage due directly or indirectly to misuse, abuse, negligence or accidents; repairs or alterations outside our facilities; or to lack of maintenance. We shall in no event be liable for death, injuries to persons or property or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS. To take advantage of this warranty, the product or part must be returned to us with transportation charges prepaid. [. . . ]