User manual CHICAGO 94137

[. . . ] Write the invoice number on the front of this instruction sheet. Keep this instruction sheet and invoice in a safe and dry place for future reference. UNPACKING When unpacking, check to make sure all the parts shown on the Assembly Diagram are included. If any parts are missing or broken, please call Harbor Freight Tools at the number above as soon as possible. SAFETY WARNINGS AND PRECAUTIONS 1. Make sure to wear ANSI approved safety impact eye goggles when installing this Light Kit. [. . . ] Then connect to the Brown wire in the back of one Tail Light (either side) provided in this Kit. Replacement parts and accessories: When servicing, use only idential replacement parts. Only use accessories intended for use with this product. People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker. The warnings and precautions discussed in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. 4. 5. 6. 7. 8. 9. ASSEMBLY INSTRUCTIONS Vehicle Connection: 1. Connect the BROWN (B) wire of the Color Coded Trunk Harness (4) to the towing vehicle's Tail Light wire. Connect the YELLOW (A) wire of the Color Coded Trunk Harness to the vehicle's Left Hand Stop & Turn light. Connect the GREEN (D) wire of the Color Coded Trunk Harness to the vehicle's Right Hand Stop & Turn light. Make sure to use the BLUE Wire Splitter Connectors to make these connections. (See Illustration below) Attach the WHITE GROUND (C) wire to the towing vehicle's frame. Diagram. ) NOTE: If the towing vehicle has rear turn signals separated from its stop lights, you will need to install additional hardware. COLOR CODED TRUNK HARNESS (4) C D DAB A. BROWN WIRE (TAIL LAMP, MARKER, CLEARANCE & LICENSE) C. WHITE WIRE (GROUND) A B C C SPLIT Y-STYLE HARNESS (3) A BA C D. SIDE STOP/TURN SIGNAL) SKU 94137 For technical questions, please call 1-800-444-3353 PAGE 2 Trailer Light Mounting And Connection: 1. Mount the Stop-Tail-Turn Light (1), marked "L. H. " (with the License Window), on the left rear of the trailer with its side marker to the outside of the trailer. Then, mount the License Plate Bracket (2) with the Stop-Tail-Turn Light. (See Illustration on previous page) Mount the Stop-Tail-Turn Light (1), marked "R. H. " (without the License Window), on the right rear of the trailer with its side marker to the outside of the trailer. Diagram) Use the Metal Frame Clips included in the Mounting Hardware Package (5) to mount each half of the Split Y-Style Harness (3) down each side of the trailer. [. . . ] 7. 8. 9. 1 1 3, 4 5: MOUNTING HARDWARE NOT SHOWN. 2 (Due to continuing improvements, actual product may differ slightly from the product described herein. ) Part # 1 2 3 Description Stop-Tail-Turn Light License Plate Bracket Split Y-Style Harness Qty. 2 1 1 Part # 4 5 Description Color Coded Trunk Harness Mounting Hardware (1 package) Qty. 1 1 NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. [. . . ]