User manual CHICAGO 95811

[. . . ] It is important that you read the entire manual to become familiar with this product before it is installed or used. if you dO nOt have experience doing this type of electrical work, the job should be done by a qualified automotive or electrical service technician. Cluttered benches and dark areas invite accidents. wear ansi-approved safety goggles and heavy-duty work gloves during installation or service. [. . . ] Select a proper location to mount the Off Road Light and mark it. The Light may be either top or bottom mounted. If there is no hole for mounting your Light, you must drill one at the point you have selected. Attach Positive wire (not included) to the proper terminal near the base of the Off Road Light before the Light is mounted to the vehicle. There is only one, it is easy to locate. Insert Positive wire (not included) and Black Ground Wire (6) through the hole next to where you wish to mount your Light. figure 1 Rubber Mounting Pads (7) 4. 5. Nut & Washer (8) 6. Place one of the Rubber Mounting Pads (7) against the upper and lower sections of the Light mounting hole. Use the Washer and Nut (8) provided to secure the Light snuggly to your vehicle. The Rubber Mounting Pads (7) attached to the base of your Off Road Light help to keep it from vibrating loose when driving on rough terrain. See figure 1 SKU 95811 for technical questions, please call 1-800-444-3353. Page 4 Figure 2 Required: Switch/Fuse (not included) rated at 15 amps or larger. Red Positive wire (not included) Fuse Switch Black Ground Wire (6) Battery 7. The red Positive wire (not included) from the Light is the "HOT" wire. Use a pin connector or in-line splice connector (both not included) to connect the Off Road Light to your vehicle's electric wiring system. When using an in-line splice connector, it is not necessary to strip the wires. The wiring diagram in figure 2 will give you a basic idea of how to set up the wiring. The red Positive wire (not included) runs from the light to the Fuse, then to the switch. From there it is wired to the electrical wiring running to the battery. The Black Ground Wire (6) (included) must make contact with a metal surface to assure proper grounding. Attach the Red Positive wire (not included) to a switched power wire (e. g. tail light or the low beam of the head light). Then wrap the connection with water proof tape (not included). Lay the connector for the switch (not included) of the wiring harness into the driver's compartment through the fire wall. Use a hole already made for the purpose of handling other wires. Use double sided tape to secure the switch in the place you want it to remain. [. . . ] This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, or to lack of maintenance. We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent, special or consequential damages arising from the use of our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion may not apply to you. THiS WarranTy iS expreSSly in lieu oF all oTHer WarranTieS, expreSS or implied, inCluding THe WarranTieS oF merCHanTabiliTy and FiTneSS. [. . . ]