User manual CHICAGO 96157

[. . . ] 5 IN 1 PORTABLE POWER PACK Model 96157 OPERATION INsTRuCTIONs Visit our website at: http://www. harborfreight. com Read this material before using this product. Failure to do so can result in serious injury. sAVE ThIs MANuAL. Copyright© 2007 by Harbor Freight Tools®. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. [. . . ] Lead acid batteries generate additional hydrogen gas when charging. Only use the Jump-start System in a well-ventilated area. Never exceed the maximum charging time of the Power Pack. Maximum DC charge time is 24 hours. 20. sERVICE 1. Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury. When servicing a tool, use only identical replacement parts. Follow instructions in the "Inspection, Maintenance, And Cleaning" section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury. uNPACKING When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. OPERATION INsTRuCTIONs Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. Charging the Power Pack Note: Before initial use, it is necessary to completely charge the Power Pack. Initial charge time when using an AC outlet is 48 hours. Initial charge time when using a DC outlet is 24 hours. Always charge on concrete or tile, not on surfaces that are flammable or surfaces that could get heat damaged. Press and hold the Battery Status Button (23) on the front of the unit to check the battery power level: 13 - 15 Volts is ready for use, 12 Volts needs to be charged, less than 12 Volts should be charged immediately. Turn the Jump-start Power Switch (18) on the back of the unit to the "OFF" position. REV 09e 2. SKU 96157 For technical questions, please call 1-800-444-3353. Page 4 DC Adapter (31) 3. AC Adapter (30) To charge from an AC power source. After the initial charge, use only the AC Adapter (30) provided with the unit. Plug first into any standard 120V socket, and then into Power Pack. Allow up to 34 hours for the unit to fully charge. The pack must not be continually charged for over 34 hours at a time. When the Power Pack is fully charged, unplug from the 120V socket and unit. Do not exceed the maximum AC charge time of 34 hours. To charge from a DC power source, plug the DC Adapter (31) into any 12V outlet and then into the AC/DC charging jack on the front of the unit. [. . . ] Before connecting the Inverter, make sure the Inverter/Fan Switch (26) is in the "OFF" position. (Push on "0" portion of the switch) Plug the appliance into an AC Socket (29) of the Power Pack. Press the Inverter/Fan Switch to the "ON" position. If the inverter is working correctly, the light underneath the Inverter/Fan Switch will illuminate green. [. . . ]