User manual CHICAGO 97047

[. . . ] AC/DC power inverter 1, 000 wAtt / 2, 000 wAtt Model 97047 Set up AnD operAting inStruCtionS Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Distributed exclusively by Harbor Freight tools®. 3491 Mission Oaks Blvd. , Camarillo, CA 93011 visit our website at: http://www. harborfreight. com read this material before using this product. Failure to do so can result in serious injury. [. . . ] Performance of this unit may vary depending on the available battery power or appliance wattage. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. 7. 10. SAve tHeSe inStruCtionS. grounDing wArning improperly connecting the grounding wire can result in electric shock. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provided with the tool. never remove the grounding prong from the plug. Do not use the tool if the power cord or plug is damaged. if damaged, have it repaired by a service facility before use. if the plug will not fit the outlet, have a proper outlet installed by a qualified electrician. SKU 97047 For technical questions, please call 1-800-444-3353. Page grounded tools: tools with three prong plugs 1. Tools marked with "Grounding Required" have a three wire cord and three prong grounding plug. The plug must be connected to a properly grounded outlet. If the tool should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user, reducing the risk of electric shock. (See 3-prong plug and outlet. ) The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the tool. The green wire in the cord must be the only wire connected to the tool's grounding system and must never be attached to an electrically "live" terminal. (See 3-prong plug and outlet. ) The tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See 3-prong plug and outlet. ) 2. 3. 3-prong plug and outlet outlets for 2-prong plug Double insulated tools: tools with two prong plugs 1. Tools marked "Double Insulated" do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc. , the Canadian Standard Association, and the National Electrical Code. (See outlets for 2-prong plug. ) Double insulated tools may be used in either of the 120 volt outlets shown in the preceding illustration. (See outlets for 2-prong plug. ) 2. extension Cords 1. [. . . ] If the low battery alarm is on all the time, try these corrective measures: Recharge battery if in poor condition. If you are getting a low output voltage, try reducing the load to minimize watts. Also, keep input voltage above 10. 5 volts to maintain a constant flow of power. If you are not getting any power output, turn the power switch Off and On again, until the green power light comes on. [. . . ]