User manual CHICAGO 97577

[. . . ] To prevent death, serious injury and vehicle damage: 1. NEVER operate vehicle engine inside garage, EVEN IF doors and windows are open. WARNING 4. [. . . ] (California Health & Safety Code § 25249. 5, et seq. ) 3. Wear ANSI-approved safety goggles and heavy-duty work gloves during use. Functions: Engine Result Test Results Bulb Likely Cause Does not start Flashes Fuel system fault Does not start Does not flash Ignition fault Starts Flashes weak/inconsistent Ignition fault Bulb Replacement: Base Cap The ChECk LIGhT illuminates to show a spark passing through it. The wire from the coil is attached to the metal post on the bulb end. The black boot leads to the spark plug/ground. 1. Unthread the Cap from the Base of the Check Light and remove the Bulb/Spring Assembly. Remove the old Bulb and dispose of properly. Bulb/spring Assembly The ExTENsIoN is used to connect the spark checker to recessed plugs. The black boot of the check light connects to the exposed metal tip of the extension. The opposite end of the extension connects to the spark plug. 3. Insert a new GE part NE51H (B2A) or equivalent Bulb into the Spring. Insert the Bulb, cover first, into the wider end of the Spring. [. . . ] The black boot of the check light connects to the exposed metal tip of the clamp. The alligator clamp connects to a grounded portion of the engine. distributed exclusively by harbor Freight Tools. sAVE ThEsE INsTRuCTIoNs. 08b Made in China. [. . . ]