User manual CHICAGO UNDERHOIST STAND WITH FOOT PEDAL

[. . . ] When not in use, the Underhoist Stand must be stored in a dry location to inhibit rust. Always lock up products and keep out of reach of children. There are certain applications for which the Underhoist Stand was designed. It will do the job better and more safely supporting a load for which it was intended. [. . . ] The Underhoist Stand is not designed to solely support heavy components. Make certain to place the Underhoist Stand on a dry, clean, solid level surface capable of supporting the Underhoist Stand, the vehicle and parts being hoisted, and the initial source of secure support for the vehicle parts. Always check hardware and assembled parts after assembling. All connections should be tight and hardware tightened. When using the Underhoist Stand, whenever possible, keep personnel clear of the area under the item being adjusted. Failure to heed all instructions and warnings may result in death, personal injury, and /or property damage. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpacking When unpacking your Underhoist Stand with Foot Pedal, check to make sure the following parts are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353. Assembly Your Underhoist Stand will require complete assembly prior to use. It is important that you read the entire manual to become familiar with the product BEFORE you assemble and use the Underhoist Stand. Before assembling and operating the Underhoist Stand be sure that you have all parts described in the Parts List and Assembly Diagram located on the last pages of this manual. Thread the Holder (19) into the Base (21). Thread the Handle (3) into the Metal Support (6). Screw the Threaded Post (7) down into the the Metal Support (6). Continue to screw the Threaded Post (7) down until most of the Threaded Post (7) is down inside the Metal Support-see Figure 1. Thread the Saddle (1) onto the top of the Threaded Post (7)-see Figure 1 and Figure 2. Screw in Lock Pin (2) to secure the Saddle (1) in place-see Figure 2. SKU 92258 For technical questions please call 1-800-444-3353. 5. Figure 1 Saddle (1) Figure 2 Saddle (1) Threaded Post (7) Lock Pin (2) Handle (3) Metal Support (6) 6. 7. Thread the Holder (19) down into the Base (21)-see Figure 3. Set the Metal Support (6) down into the Holder (19). [. . . ] This is the only purpose of this Underhoist Stand. Never attempt to use the Underhoist Stand to support a load. Reverse the order of steps one through five to lower the Underhoist. Make certain that at all times the load is fully supported by other means than the Underhoist Stand. SKU 92258 For technical questions please call 1-800-444-3353. [. . . ]