User manual CHICCO CT0.6

[. . . ] Ensure that all persons who operate this stroller know how to operate it safely. Do not allow children to play with or hang on the stroller. Do not use your stroller for anything other than its intended purpose. Be careful when going up or down curbs, stairs, and escalators. [. . . ] This adjustment is difficult when the child is in the seat. We recommend that you recline the backrest before you place your child in the stroller. Avoid serious injury from falling or sliding out. Do not allow your child to climb into the stroller without assistance. If the stroller has been exposed to direct sunlight for a prolonged period of time, wait until the stroller cools down before placing your child in it. After placing your child in the stroller, pass the shoulder straps over his/her shoulders and attach them to the fasteners. Never leave your child unattended in the stroller, even if the brakes are applied. Never leave the stroller on a sloped surface with your child on board, even when the brakes are applied. Hold on to your stroller when close to moving vehicles and trains. Even with the brakes on, the draft from the vehicle may move the stroller. To set the front wheels to swivel, raise the swivel lock between the two front wheels. use the swivel wheel mode on smooth surfaces. To lock the front wheels in place, lower the swivel lock. To provide the smoothest ride for your child, we recommend that you lock the swivel wheels on uneven surfaces, such as gravel. Rock the stroller back and forth to make sure the brakes are fully applied. To release the brakes, raise the brake levers. To protect your child from the sun, use the sun canopy on the stroller. to do this , attach the clips on the canopy to the frame of the stroller , as shown. Be sure to close the canopy before you close the stroller. Release the red lock with your foot by pulling and lifting it at the same time. [. . . ] Brakes, wheels, and tires are subject to wear and should be replaced if necessary with parts supplied by the manufacturer. Should the parts become stiff or difficult to operate, first ensure that dirt is not causing the problem. Then, lightly apply a silicone based lubricant between the components. Do not overspray, as this may cause dirt to accumulate. [. . . ]