User manual CHICCO CUOCIPAPPA SANOVAPORE

[. . . ] Den skall tas till en uppsamlingsplast för elektriska och elektroniska apparater eller lämnas tillbaka till återförsäljaren när man köper en liknande produkt. För en mer detaljerad information gällande disponibla uppsamlingssystem så vänd Er till lokala avfallshanterare eller till affären där produkten köptes. The crossed bin symbol on the appliance indicates that the product, at the end of its life, must be disposed of separately from domestic waste, either by taking it to a separate waste disposal site for electric and electronic appliances or by returning it to your dealer when you buy another similar appliance. The user is responsible for taking the appliance to a special waste disposal site at the end of its life. [. . . ] Read carefully the instruction booklet, recipe book and warnings, and keep them for future reference. IMPORTANT: All products coming into contact with foodstuffs should always be cleaned thoroughly before use. To this end, prepare the equipment as indicated in chapter VI. HOW TO USE THE EQUIPMENT, pour 150 ml of drinking water into the boiler and perform a warming up cycle without placing any food in PureSteam Cooker. Let the equipment cool down first, then remove the jug (8) and any residual water. Before carrying out a cleaning cycle, check that the jug (8) and all internal components but the cooking rack (7) have been removed. Note: For safety reasons, the jug (8) and lid can be removed only if the ON/OFF switch (2) is in the "0" position. C1) and remove the jug (8) from its housing, pulling it from the rear (diag. Fit the lid to the jug (6), taking care that the notches coincide (diag. Hold the jug from the handle and insert it into the base, as shown in diagram A, taking care to fitting the jug properly in its housing (if it is positioned correctly, the jug locks onto the raised support located on the base). Insert the rack (7) into the jug (8) and close the lid (6), then fit the jug (8) onto the base (1), as shown in the JUG section. Never use the cooking function unless the cooking rack (7) is fitted to the jug (8). select the desired cooking time pressing the appropriate buttons (5 to increase the cooking time; 6 to decrease it). The cooking time can vary from 1 to 30 minutes maximum (unless a specific cooking time is selected, PureSteam Cooker will automatically select 30 minutes cooking time). The cooking process stops automatically when the countdown ends. at this point PureSteam Cooker will emit an acoustic signal (5 consecutive "beeps") , and the symbol will flash on the display (3). If the boiler runs out of water before the selected cooking time has passed, PureSteam Cooker will automatically stop the cooking process and emit an acoustic signal (a continuous "beep" for 10 seconds). The icon indicating the cooking function on the display will switch off and the "add water" icon and residual time of the cooking function selected at the beginning will start to flash. In case you wish to modify the cooking time after the cooking cycle has already started, simply press the + button (to increase the time) or ­ button (to decrease it) to make the adjustments you wish (never over 30 minutes). Handle these parts with extreme care since they could be very hot (see the JUG section). Remove the cooking rack (7) paying maximum attention since it may be very hot. It is recommended to carry out this operation using an oven glove or a pot holder. [. . . ] the jars feature a graduated scale for measuring liquids or baby food inside the jar. Follow the guidelines provided below to warm up baby food in the jars. - Before warming up baby food, always remove the lid from the jar. - Do not place the jars directly onto gas rings, warming plates, electric ovens, etc. [. . . ]