User manual CHICCO ERGO GYM BABY TRAINER

[. . . ] It is dangerous to put the Baby Trainer on an elevated surface, , such as tables, chairs, etc. Age for use in the baby seat position: from birth up to 9 Kg of weight (6 months approximately). Do not use the Baby Trainer in this position when the child is able to sit on its own. Do not use the Baby Trainer with more than one child at a time. [. . . ] A "click" will be heard when the joints are released, indicating that they are fitted in the correct position. Press both the panel side joints at the same time, until the panel reaches position C, as shown in diagram M-1. A "click" will be heard when the joints are released, indicating that they are fitted in the correct position. Raise the backrest, until the notch located on the backrest joint reaches position n. A "click" will be heard when the joints are released, indicating that they are fitted in the correct position. Lower the backrest support, as shown in diagram M-3, and check that it is locked correctly into position. Raise the playmat and pass the strap through the 3 holes (right, left and bottom), as shown in diagram M-7. Place the child as shown in diagram M-8; then fasten the fabric straps into the buckle, as shown in diagram M-9. When the Baby Trainer is in use, remember to always fasten the safety harness, inserting it through the crotch strap, and ensure that it is fastened correctly. Age for use in the baby seat position: from birth up to 9 Kg of weight (6 months approximately). Do not use the Baby Trainer in this position when the child is able to sit on its own. Always use the safety harness and crotch strap when the child is sitting in the Baby Trainer in the baby seat position. WARNING: The Baby Trainer has not been specifically designed for a child to sleep in. If your child needs to rest, it is recommended to lay it in a crib or cot. Pass the fabric straps under the playmat through the appropriate hole, as shown in diagram N-1; ensure that they do not prevent the baby from lying on its tummy. Press both the panel side joints at the same time, until the panel reaches position A, as shown in diagram N-3. A "click" will be heard when the joints are released, indicating that they are fitted in the correct position. Lift the frame from the floor, as shown in diagram N-4. Raise the backrest support, as shown in diagram N-5, and replace it inside the backrest, as shown in diagram N-6. Lower the backrest until the backrest reaches position n. The teething ring can be inserted in both sides, which have a slot where the triangular base of the teething ring can be inserted. To check whether the frame is in the correct position, ensure that the notches located on the joints are positioned on the 1/A combination. [. . . ] Always keep batteries and tools out of reach of children. Always remove spent batteries from the toy to avoid the danger of leakage from the battery damaging the product. Always remove the batteries if the toy will not be used for a long period of time. Only use alkaline batteries of the same type or equivalent to the type recommended for the correct function of this product. [. . . ]