User manual CHICCO HOOPLA

[. . . ] •  ARNING: The reclined cradle W does not replace a bed or a crib. If the child needs to sleep, then it should be put in a bed or crib. €  ARNING: Do not use the reW clined cradle if any components are broken or missing. €  ARNING: Do not use accessories W or replacement parts other than those approved by the manufacturer. [. . . ] WARNING: Always check that the backrest is properly locked before use. The reclined cradle is equipped with transport handles made of fabric. WARNING: The transport handles (I), when not used, shall be fixed on the back of the backrest with the velcro ribbons. The reclined cradle can be used in fixed or rocking mode: •  ixed mode: turn the front feet (B) clockwise until the lower part of F the foot touches the ground (Fig. 6); •  ocking mode: turn the front feet (B) in the opposite direction (counR ter-clockwise), so that the foot is not touching the ground (Fig. The reclined cradle can be closed for transport. WARNING: The reclined cradle must never be closed with the child sitting in it. Remove the child from the reclined cradle before closing the frame! o close the reclined cradle, press the 2 buttons inside the front T feet (Fig.  o open the reclined cradle again, just pull the seat upward (Fig. 9) T until you hear a click that indicates the correct opening.  he safety harness is pre-fitted and ready for use the first time you T use the reclined cradle (Fig. To release it, press the toothed ends of the clasp and remove the two clasps (Fig. WARNING: When using, always remember to fasten the belt by passing it around the crotch strap and check it is tight enough and in the right position. It is possible to alter the tightness of the belt by adjusting it and passing the fabric around the back of the backrest.  eep one clasp end blocked and simultaneously pull the belt K and slide it inside the relative ring (O), to adjust the tension of the s BO 10 Po wit the (Fig TO 11 12.  he reducer cushion D - DD is ideal from birth and can be reT moved according to needs. To fix it to the seat, place it on the seat and slide the crotch strap through the hole (Fig. Thread the safety harness in the relative side slots of the reducer cushion (Fig. Position the headrest DD at the desired height; it can be chosen within three different heights; fix the headrest to the seat, sliding the straps through the slot and close it again using the velcro strap (Fig.  asten the toybar (E) to the frame inserting the lower ends in F the relevant fastening holes of the bar support (Fig. Always check that the toybar is properly fastened before every use. [. . . ] €  he dimensions of the product are T 80 x 43 x 32/62 cm. €  ägg inte till snören för att förlänga L upphängningarna på lekbågens hängande lekföremål och gör inga knutar/öglor: Det kan då oavsiktligt bildas löpknutar som kan medföra risk för strypning. , for at undgå risici eller fare for antænding. €  lacér aldrig liggestolen i nærheP den af vinduer eller vægge, for at undgå risikoen for, at barnet kan læne sig ud og falde ned. [. . . ]