User manual CHICCO I-FEEL

[. . . ] € WARNING: Never leave the rocking cradle on surfaces which are not perfectly level. € WARNING: Never use the toy bar to carry the reclined cradle. € WARNING: Always use the restraint system when the child is in the rocking cradle; adjust the length of the straps as necessary. € WARNING: Do not allow children to play unsupervised near the rocking cradle. [. . . ] € WARNING: If using rechargeable batteries, remove them from the toy before recharging them. € WARNING: Do not leave the product out in the rain; water infiltrations will damage the electronic circuit. € WARNING: Using the MP3 device will have an effect on how long the toy batteries last. € WARNING: The choice of music and volume are controlled from the connected MP3 player. A declines all responsibility for any faults or malfunctions of the MP3 device. € WARNING: The cleaning and maintenance operations must only be carried out by an adult. € WARNING: Periodically inspect the rocking cradle to check for broken, torn or missing parts: if this is the case, do not use it. € Please refer to the care label for instructions on how to wash the fabric parts. Hand wash in cold water Do not bleach Do not use a dryer Do not iron Do not dry clean • Check that the fabric and stitching are in good condition each time you wash it. € Prolonged exposure to direct sunlight can cause the fabric to fade. Maintenance Only use water and a soft damp cloth to clean the toy bar and the vibration block. (GB) This product complies with EU Directive 2002/96/EC. The crossed bin symbol on the appliance indicates that the product, at the end of its life, must be disposed of separately from domestic waste, either by taking it to a separate waste disposal site for electric and electronic appliances or by returning it to your dealer when you buy another similar appliance. The user is responsible for taking the appliance to a special waste disposal site at the end of its life. If the disused appliance is collected correctly as separate waste, it can be recycled, treated and disposed of ecologically; this avoids a negative impact on both the environment and health, and contributes towards the recycling of the product’s materials. For further information regarding the waste disposal services available, contact your local waste disposal agency or the shop where you bought the appliance. Parts a) Seat b) Back rest tube c) Booster cushion d) Crotch strap e) Safety harness f) Structure g) Wooden base h) Adjuster handle i) MP3 pocket j) Feet k) Fabric fastener tube l) Wooden toy bar m) Toy bar joint n) Music/lights ON/OFF buttons o) Toy bar luminous panel p) Fabric toy q) Closing lever Assembly and User Instructions 1. Open the rocking cradle frame by holding onto the tube, as seen in diag. Take hold of the backrest tube B and insert it in the end of the frame tube, as seen in diag. WARNING: Always check that the safety harness straps are inser- 17 ted in the backrest tube before assembling the rocking cradle. It is important to remember to always secure the fabric seat A to all fastener points on the frame: fasten the buttons on both sides of the fabric to the frame, as seen in diag. 3 and 3A, until you hear them click into place. [. . . ] To select the rocking position, simply rotate feet J backward, following the directions of the arrow (diag. When you want to use the rocking cradle in a fixed mode again, turn the handle in the opposite direction (diagram 16A). It is possible to remove the seat cover and the booster cushion to wash them: undo the harness belts and remove the booster cushion from the crotch strap (diag. Slide the harness straps through the side slots in the fabric, open the zip (diag. [. . . ]