User manual CHICCO KEY 1 ISOFIX

[. . . ] Prior to purchasing your child car seat, always ensure that specific child car seat use is authorised for your car. ⷠThe child car seat adjustment operations must only be carried out by an adult. ⷠThe product must not be used by anybody who has not read these instructions. ⷠThe risk of serious injuries to the child increases, not only in the case of accidents, but also in other circumstances (i. [. . . ] Do not use anything, for example pillows, blankets, etc. It is intended for general use in vehicles, and it will fit most, but not all car seats. A correct fit is more likely if the vehicle manufacturer has declared that the vehicle is capable of accepting a "Universal" child restraint for this age group. This child restraint has been classified as "Universal" under more stringent conditions than those that were applied to earlier designs not displaying this notice. Only suitable if the vehicle is fitted with a 3point static or 3-point retractor safety belt, type approved to UN/ECE Regulation No. If in doubt, consult either the child restraint manufacturer or the retailer. Intended use of both item and vehicle seat, restrictions and requirements · Child car seat installation into the vehicle · Warnings for correct child car seat installation · Seating the child into the child car seat · Child car seat base frame K. Child car seat harness straps connection plate Fig. This is a "Universal" child restraint. Car safety belt horizontal strap guide Car safety belt diagonal strap lock clamp Installation instruction label Guide for inserting the diagonal part of the car safety belt Please read and observe the following instructions very carefully. They refer to both the child car seat and the vehicle seat. Open the car safety belt diagonal strap lock clamp (R) located on the same side of the seat buckle, by pressing down on its lever (Fig. Slip in the car safety belt diagonal strap positioning it exactly as illustrated in fig. Release the lever of the lock clamp (R), it will automatically retract into its lock position. Pull very firmly on the car safety belt diagonal strap, ensuring that the child car seat is very tightly lodged to the vehicle seat (Fig. If necessary, use one knee to press down on the child car seat. Insert the upper part of the diagonal belt inside the T guide, placing it exactly as shown in diagram 14. Pull the safety belt in the direction shown in diagram 14 firmly to tighten also the last part of the belt. Check overall installation to make sure that the child car seat is fitted correctly (Fig. To avoid safety hazards, after installation, ALWAYS check to make sure that: - the car safety belt is absolutely not twisted anywhere; - the car safety belt is correctly tensioned in all areas; - the child car seat is well locked onto the vehicle seat. If it is not, go through the whole installation procedure from the start. pLACING THE CHILD INTO THE CHILD CAR SEAT - Before seating the child , press the strap adjustment pushbutton. [. . . ] For correct child car seat harness straps ten27 26) until the straps and belts fit perfectly to the child's body. Once the straps and belts have been adjusted, take hold of the shoulder straps and pull downwards. The strap must be accurately and well tensioned, adhering to the child's body without being too tight: at shoulder level, it must be possible to fit a finger in between the child's shoulder and the harness strap. Check that the straps/belts are not twisted anywhere along the strap/belt length. [. . . ]