User manual CHICCO KEY 2-3

[. . . ] Befolgen sie bitte aufmerksam diese anleitung, um nicht die sicherheit ihres kindes zu beeinträchtigen Important: please read these instructions carefully before use and keep them for future reference. For your child's safety, read these instructions carefully. This child car seat is approved for "Group 2 ­ 3", for the transport of children from 15 to 36 Kg of weight (between 2 and 12 years of age approximately) and conforms to European norm ECE R 44/04. Each country has different safety laws and regulations for the transportation of children in cars. [. . . ] If the child car seat is fitted in the front seat of the car, it is recommended to push the seat back as much as possible, bearing in mind the comfort of the passenger sitting in the seat directly behind it and to adjust the backrest in the most vertical position. If the car is equipped with a safety belt height adjuster, fix it in the lowest position, then check that the car seat safety belt adjuster is either in a backward position with respect to the backrest of the car seat (or at least aligned to it) (see diag. If the front seat is equipped with frontal airbag, it is recommended that you fit the child car seat into this seat. If you wish to fit the child car seat in any seat protected by airbag, always refer to the vehicle instructions manual. MAINTENANCE The cleaning and maintenance operations must only be carried out by an adult. How to Clean the Fabric cover The child car seat's fabric cover can be removed and cleaned. Please refer to the care label for instructions on cleaning the seat fabric. Clean the fabric cover only with a sponge, neutral detergent and water. never use abrasive detergents or solvents. Do not spin the fabric cover, let it dry without wringing. The fabric cover can be replaced only with another fabric cover approved by the manufacturer, because it is an integral part of the child car seat and, therefore, it is a safety aspect. The child car seat must never be used without the fabric cover: it could be dangerous for your child. How to Clean the Plastic Parts Clean the plastic parts with a soft, damp cloth or a neutral detergent. never use abrasive detergents or solvents. The movable parts of the child car seat must not be lubricated. Checking the Condition of the Components It is recommended to check regularly the condition of the following components to ensure that they are not worn out: · Fabric cover: Check that the padding does not come out from the seams. Check the condition of the seams: they must always be integral. Plastic parts: Check that the plastic parts are not worn out, damaged or faded. If the child car seat is deformed or worn out, it must be replaced: it may no longer comply with the original safety standards. Storing the Product When it is not fitted into the car, it is recommended to store the child car seat in a dry place, away from sources of heat and to protect it from dust, humidity and direct sunlight. iNSTRUCTIONS Index · How to fit the child car seat into the car and place the child into the child car seat · How to remove the child from the child car seat. How to fit the child car seat into the car without the child. [. . . ] Turn the 4 handles, until they coincide with the OPEN symbols (diag. At the end of the operation, check that the small reference circles, located on the base, and the handles are aligned, and that the two parts are correctly unlocked. Position the child car seat as shown in diag. Raise the upper part of the child car seat, removing at the same time the rear panel of the backrest (diag. [. . . ]