User manual CHICCO LULLABY LX

[. . . ] Failure to follow these warnings and the assembly instructions could result in serious injury or death. Playard MUST be fully assembled with all top rails and center floor handle locked into position prior to use or attaching bassinet. â· DO NOT place child in playard unless all top rails and center floor handle are securely locked into position and floor pad is in proper place. Infant may roll into space between pad and loose mesh sides causing suffocation. [. . . ] â· Do not use changing table as a sleeping or play area. â· Always remove the changing table when your child is in the playard. If you are without an owner's manual, do not use this product. Attach both metal end pieces to poles, making sure metal spring button pushes completely through the holes. When using changing table, be sure to secure child with waist belt located on changing table. To fit the waist belt snugly, fasten the buckle together and pull tight on strap for a snug fit. Turn changer over and secure underneath with velcro. If changing table is not secured, child in play yard can lift or shift changing table and get neck trapped between changing table and play yard frame. Never leave changing table in place when child is in play yard. NOTE: All 4 buckles and the zipper must be securely fastened when changing table is in use. do not mix alkaline , standard (carbon-zinc) , or rechargeable (nickel-cadmium) batteries. Remove batteries before storing this product. Before attempting to operate the corner electronics unit, install four AA batteries matching the polarity indicated inside battery compartment. Turn the changing table over to the outside of the playard. DO NOT use the electronics unless it is attached to the corner cap of the playard. The plus (+) sign increases volume and the minus (-) sign decreases volume. Press down gently ensuring that it is resting securely into place. MANUAL ON: Slide the on-off switch to ON-6 position to enable activation of any mode for about 6 minutes. REMOTE ON: Slide the on-off switch to the REMOTE position to enable activation of any mode with REMOTE control unit. SOUND ACTIVATED ON: Slide the on-off switch to the ON-6 position to enable activation of both music and vibration with sudden sounds (i. The electronics unit will gently vibrate for about 6 minutes before automatically turning off. lIGHT: Push the button wih the light bulb. [. . . ] Pull handle to bring floor completely up and gather legs together. Turn unit upright with wheels on ground. Wrap floor pad around folded playard (26A). Thread fastening straps through rings on floor pad (26B). [. . . ]