User manual CHICCO MARSUPIO YOU AND ME

[. . . ] Always ensure that the child has sufficient space around its face to breathe properly. Do not use the Baby Carrier if any parts are damaged, torn or missing. Do not fit to the baby carrier any accessories, spare parts or components not supplied or approved by the manufacturer. WARNING: Your balance may be adversely affected by your movement and that of your child. [. . . ] Information for parents: Some sizes/heights are indicated near the height adjustment buckle of the baby carrier, in order to make the adjustment operations easier. WARNING: Before placing the child in the baby carrier, ensure that the adjustment buckle is fastened correctly into position. hOW TO FIT THE BABY CARRIER TO THE SHOULDER STRAPS 8. To fit the baby carrier to the shoulder straps, it is necessary to hold the lower buckles of the shoulder straps and fasten them to the corresponding lower open/close buckles of the baby carrier (diag. Heard, indicating that the buckle is fastened correctly into position. Adjust the length of the shoulder straps, one at a time, adjusting the secondary adjustment straps, until the baby carrier is closely positioned against the upper part of the adult's thorax (diag. This operation is necessary to ensure maximum comfort for the adult and the child and to distribute the weight in the best way, so ensuring maximum safety for the child. ADJUSTMENT SYSTEM FOR THE PARENT'S BODY WARNING: This operation must be carried out before placing the child into the baby carrier. The baby carrier has an adjustment system that ensures maximum comfort and the best adjustment to any type of body size. Hold the two ends of the upper open/close buckle with the fingertips and exercise a slight pressure on the sides to unfasten the buckle (diag. Raise the tab to release it from its position of use (diag. Slide the buckle set into the appropriate guide, until the desired height is reached (diag. Lower the buckle, and exercise a slight pressure on the side of the tabs to fasten the buckle again in its safety position (diag. Both shoulder straps must be adjusted exactly at the same height. To carry the child in a correct and safe position, the adjustment buckle must be positioned as shown in diagram 14. WARNING: Always check that the buckle is fastened correctly before carrying out any other operations. It will be impossible to fit the baby carrier to the shoulder straps if this adjustment operation has not been carried out correctly and the tabs are not fitted correctly into position. HOW TO PLACE BABY INSIDE THE BABY CARRIER It is recommended that you place the child in the baby carrier while sitting. FACING INWARD WARNING: Before placing the child inside the baby carrier, ensure that the baby carrier is fitted to the shoulder straps as indicated above, and that both the side adjustment buckles and upper open/close buckles are unfastened. After fitting the baby carrier to the shoulder straps, fasten the side adjustment buckle, located at the height of he child's waist, only on one side of the baby carrier (diag. Fasten the corresponding upper open/close buckle, exercising pressure on the red tab (16 A) and fastening the buckle to the joint located on the shoulder strap, until a "clack" is heard, indicating that it is fastened correctly into position (diag. WARNING: Check that both buckles are fastened correctly. [. . . ] Open the panel, which allows you to carry the child facing forward, with the appropriate zips (diag. Fix the panel with the appropriate buttons (diag. WARNING: Do not open the zip, which allows access to the height adjustment buckle, more than the other zip, which allows you to open the headrest. It is necessary to always adjust the width Ensure that the baby carrier is neither too large nor too tight, and that it fits baby's body correctly (diag. [. . . ]