User manual CHICCO MIA

[. . . ] € WARNING: Do not use the bouncing chair for more than one child at a time. € WARNING: Never leave the bouncing chair on surfaces which are not perfectly level. € WARNING: Do not allow children to play unsupervised near the bouncing chair. € WARNING: To prevent the risk of fire, never place the bouncing chair near electrical appliances, gas cookers or other sources of intense heat. [. . . ] Rotate the legs outwards and connect them to the seat as seen in Diagram 1. This operation can only be performed by inserting the legs in a specific direction to avoid errors. Check that the metal pin sticks out of the relative holes correctly (Diagram 2). You will hear it click into place; try and pull it out to make sure it is fitted correctly. Also make sure that the bouncing chair carrier handles are on the outside of the frame (diagram 3). The booster cushion C is ideal for use from birth and can be removed as required later on. To fasten it to the seat, place it on the seat and around the crotch strap as indicated in Diag. See also the “BOOSTER CUSHION” paragraph. Position the head rest CC at the desired height, thread the strap through the slot on the chair and fasten in place using the velcro fastener as indicated in Diag. Fasten the toy bar on the structure, slotting it into the relative fixture. Make sure the toy bar is fitted correctly (diagram 6). To fasten the toy D to the bar, thread the fabric strap through the slots on the top of the bar, paying ATTENTION that the closure of the velcro is facing downwards. Check that the velcro fasteners are closed correctly. Release the safety harness by pressing the centre button on the buckle and at the same part extract the other part of the buckle by pressing the prongs together (diagram 8). The bouncing chair is now ready for your baby When using the chair, remember to always fasten the harness straps threading them through the crotch strap and always check they are tight enough and in the right positionThe length of the harness straps can also be adjusted from behind the backrest. Take hold of one end of the buckle and then pull the strap to the desired length as seen in diagram 9. To adjust the backrest, turn the side fixtures (diagram 10) and raise/lower it to the desired position: block the side fixtures in place by turning them in the opposite direction (diagram 11). This operation can be done with the baby sitting in the bouncing chair. It will however be slightly more difficult. Always support the backrest with one hand whilst adjusting the height. [. . . ] Position the head rest CC at the desired height, thread the strap through the slot on the chair and fasten in place using the velcro fastener as indicated in Diag. REMOVABLE COVERS It is possible to remove the slip cover and the booster cushion to wash them. Remove the safety harness from the slots in the fabric and remove the slip cover from the front, starting from the foot-rest (diagram 16). Open the Velcro fastener underneath then slide the cover over the backrest. [. . . ]