User manual CHICCO SEAT UP

[. . . ] WARNINGS • Read these instructions carefully before assembling and installing the product. Prevent anybody that has not read the instructions from using the product. € Keep this instruction booklet for future use. € Each country has different safety laws and regulations for the transportation of children in cars. [. . . ] Pull the car seat towards you and then check that the two indicators are green (Fig. 18) to make sure that the seat has been installed correctly. Make sure there are no objects between the child car seat and the vehicle seat or between the child car seat and car door. Push the child car seat firmly against the backrest of the car seat (Fig. 19) to make sure it is securely in place. The assembly of the child car seat is completed exclusively with the installation of the Top Tether (T). Refer to your car’s user manual to identify where the Top Tether of the child car sear is attached to the car. This fastening point is denoted with a specific label (Fig. 20) and can be found in the positions indicated by the figures 21A – 21B – 21C – 21D. Check that the Top Tether fastener used is the one that has been specially designated. Do not confuse it with a ring used for hanging bags (Fig. Pass the Top Tether between the top of the car seat backrest and the headrest. Never pass the Top Tether above the car headrest. extend the Top Tether belt by pressing adjustment button (V). Once you have identified the fastening point, connect to the Top Tether hook (U). Adjust the length of the Top Tether belt by forcefully pulling the belt until it is tight. The indicator on the belt goes green (W) when the tether is suitably tight (Fig. Roll up any excess belt and tie up using the velcro. To disassemble the child car seat, unhook the Top Tether and the Isofix connectors by pressing the release buttons (Q) (Fig. To put them back in completely push them inwards. When seating your child refer to paragraph 13. sEATING THE CHILD IN THE CHILD CAR SEAT 6. [. . . ] To ensure the safety of the child car seat, never use it without its fabric cover. To remove the fabric cover follow the instructions below: - Remove the headrest beginning with the top part (Fig. 54) - Remove the elastic from the diagonal belt guides (B) (Fig. 55) - Remove the elastic attached to the headrest (Fig. [. . . ]