User manual CHICCO SPRINT

[. . . ] €¢ Only Car Seat CHICCO and/or Carrycot CHICCo with the CLIK CLAK fitting device can be attached to the stroller compatible. €¢ The parking device shall be engaged when placing and removing the children. €¢ Do not overload the storage basket. €¢ Any load attached to the handle and/or on the backrest and/or the sides of the vehicle will affect the stability of vehicle. [. . . ] GENERAL INSTRUCTIONS WHEELS ASSEMBLY In some configurations, the wheels may come not assembled. In this case, assemble them as indicated below. Insert the rear wheel blocks as indicated in figure 1, until they lock in position. Then insert the front wheel block on the stroller until it locks in position (fig. Repeat this operation for the other wheel block. WARNING: before use, make sure that the wheel blocks are secured correctly, pulling them firmly. HOW TO OPEN THE STROLLER WARNING: When opening the stroller, ensure that your child, or other children, are at a safe distance. Ensure that during these operations the movable parts of the stroller do not come into contact with your child. Pull the trigger opening mechanisms, located on the handles of the stroller, at the same time; the stroller will start to open (diag. Lift the stroller towards you to make the opening operation easier (diag. Press the rear locking mechanism in a downward direction with the tip of your foot to open the stroller fully, and lock it in the open position (diag. To ensure that the harness is adjusted correctly, fitting your child and securely closed, pull firmly on the end of the harness (on the underside of the seat). To adjust the inclination of the backrest, press the button located on the backrest. Release the button to lock the backrest in the nearest position. To raise the backrest, simply push it in an upward direction (diag. WARNING: The child’s weight can make these operations more difficult. BACKREST ASSEMBLY COMPONENTS A) Backrest tube B) Connection of backrest tube C) Front release button D) Rear joint E) Rear release button 6. To assemble the backrest, insert both backrest tubes (A) in the corresponding coupling (B) as shown in fig. Once the two tubes are inserted in the coupling, rotate the rear joint (D) so as to align rib F with housing G (fig. 7A) and insert the pin present on the frame, inside the hole of the rear joint until you hear a click (fig. WARNING: before using the product in the stroller configuration, always check the correct assembly of the backrest. Fit the cover on the stroller’s backrest from the top (fig. [. . . ] When the rain cover is fitted to the stroller, never leave the stroller with the child onboard to prevent the risk of the child overheating. LEG COVER The stroller may come with a leg cover, in some configurations. The leg cover is created by using the carrycot apron (fig. To attach the leg cover, insert the leg rest in the pocket at the foot end of the leg cover. [. . . ]