User manual CHICCO TOGETHER

[. . . ] Your child’s safety may be affect if you do not follow these instructions. €¢ WARNING: children must always be strapped in their seats with their safety harness and must never be left unattended. €¢ WARNING: keep children away from all moving parts whilst you adjust the stroller. • WARNING: This stroller requires periodic maintenance by the user. [. . . ] 2B); now open the stroller by using your other hand to push the front section of the frame downwards, until you hear it click into place (diag. Make sure the stroller is open properly before proceeding any further. The rear seat on the stroller is fitted with a footrest. Once the stroller is open, lower the footrest (diag. To adjust the height of the handlebar, press the two side buttons (diag. 4) at the same time and move the handlebar to the required position. The stroller comes with a practical carry-all basket. To assemble the basket, slide the U-shaped tube into the tube ends on the back of the stroller, as seen in diag. The U-shaped tube is fitted correctly when you see the 2 grey rods on the bottom, protruding from the holes below the stroller frame tubes and you hear them click into place. To finish, fasten the fabric to the tube using the press studs (diag. Never use the carry-all basket without the supports inserted properly. Always remove all contents from the basket before you close the stroller. 6) on the back of the basket to access it more easily. Parts needed to fit the back wheels: see diag. Remove the caps from the ends of the rear axle, then slot the rear axle onto the frame, until you hear it click into place (diag. WARNING: always check the rear axle is fitted properly before using the stroller. To assemble the wheels on the rear axle A) follow the instructions in the correct order (see diag. 9A): - the wheel B) - the washer C) - the spring pin D) - the cap E) Make sure you insert the fastening spring pin as indicated in the diagram: the flat side must be inserted in the whole on the axle, whilst the closed end of the spring pin must be facing outwards (diag. Repeat the operation to assemble the other wheel, following the instructions in the same order. Slot the front wheel block onto the stroller frame as seen in diag. Repeat this procedure for the other wheel block. WARNING: check that the wheels are fitted correctly. [. . . ] WARNING: Never leave the stroller on a sloping surface with a child inside, even with the brakes applied. WARNING: after applying the brake lever, check that the brakes are locked in place on both rear wheels. SWIVEL WHEELS The front wheels on this stroller can be used in fixed or swivel mode. To use the wheels in swivel mode, lift the lever fitted between the two wheels. [. . . ]