User manual CHICCO TRIO BEST FRIEND

[. . . ] D o not leave anything inside the Cot, the installation of the carrycot carrycot that might reduce its In the car and the use during travel. properly to the stroller before placing your child inside. Do not tumble dry Light will heat up; leave them to cool down before placing the child inside. The carrycot is not designed for children to sleep in for long periods of time: this product is not a substi- Do not dry clean MAINTENANCE If necessary, lubricate with dry silicone lubricant. [. . . ] The arch can be separated from the hood fabric by unfastening the two buttons that fix it to the fabric and pulling on one of the two ends (Fig. WARNING: Carefully store the removed arch, keeping it out of the reach of children. Always dry the metal parts to prevent the formation of rust if the stroller has come into contact with water. Put the carrycot cover into position and fix it into place WASHING The external/internal lining of the carrycot and the mattress are removable and washable; to remove them, please refer to the REMOVING THE CARRYCOT LINING section. For added protection, lift the fabric flap and fix it in place using the buttons on the hood (Fig. The cover of the carrycot can be used as leg cover for the stroller. Refer to the instruction manual of the stroller for Details about the assembly of the leg cover configuration. The washing symbols and relative meanings are listed below: Wash by hand in cold water Before beginning the carrycot lining removal process, it is necessary to remove: - Cover, as outlined in point 4 - Car Kit 2013, put the lap belt into the holes in the mattress And the internal fabric of the carrycot. To remove the carrycot: - Remove the plastic flaps located in the head zone of the - Release the six elastic straps found on the external perim- eter of the carrycot (Fig. 5A) - By pulling upwards, remove the four prongs found in the Head zone of the upper edge of the carrycot (Fig. - Release the fabric from the pin located in the head zone 5D) by sliding it under the carrycot structure, then release the fabric from the pin in the foot zone (Fig. To replace the carrycot lining, repeat the steps illustrated Above in reverse order, using the images for removing the lining as guidance. - Insert the fabric beginning at the foot zone of the carrycot, being careful to stretch out the internal and external parts, keeping these separate (Fig. Fix the fabric to the pin located in the foot zone (Fig. - Slide the fabric along the structure until it is in the front part and completely covers the frame of the carrycot. Insert the pin at the head zone into the hole in the fabric (Fig. - Insert the elastic straps located on the side edge of the carrycot (Fig. 5A) and fix the prongs in the designated slots located on the rear edge in the head zone of the carrycot (Fig. - Complete the operation by inserting the plastic flaps of the internal lining between the plastic body and the Styrofoam absorbers (Fig. On the inside of the hood, between the visor and the first Section, there is a fabric ring with convenient hooks from which you can hang soft toys (fig. To adjust the hood, pull and/or push it centrally (Fig. USING THE CARRYCOT AS A PRAM This carrycot can be used as a pram, but ONLY if mounted on the "BEST FRIEND" stroller. [. . . ] The carrycot comes with a convenient carry handle that Can be adjusted in three positions (Fig. 10): A) Transport B) Middle C) Rest 11. To put the handle in the carrying position, grasp it in The centre and pull it up until you hear a click (fig. 11 ); to put the handle back in the rest position, press both buttons at the base of the handle at the same time and then turn the handle downwards (fig. [. . . ]