User manual CHICCO TRIO ENJOY

[. . . ] WARNINGS • WARNING: It may be dangerous to leave your child unattended. • WARNING: A CHILD’S SAFETY IS YOUR RESPONSIBILITY. € WARNING: Children should be harnessed in at all times and should never be left unattended. € WARNING: The child should be clear of moving parts while making adjustments. [. . . ] To fit the backrest, first fix the rear joint (F), turning it until the two locking pins located on the frame coincide with the holes located on the joint (diag. After inserting the locking pins into the holes, push the joint, until a click is heard, indicating that the locking pins are correctly locked into position (G), as shown in diagram 5. Repeat operations 4 and 5 on the other side of the backrest. Fix the front joint (C), pushing it into its appropriate housing (D), exercising a slight pressure on the tube of the backrest, as shown in diagram 6, until a click is heard, indicating that it is correctly locked into position. Repeat the operation on the other side of the backrest. WARNING: Ensure that, after carrying out the assembly operations, the adjustment levers of the backrest (B) are located under the adjustment racks (diag. If they are not positioned as shown in diagram 7 B), release the front joints of the backrest (point 8 of the instructions) and reassemble them (following the instructions indicated in point 6), making sure to position correctly the levers under the racks. Fit the fabric cover on the seat, following, in the reverse order, the strollers’ instructions indicated in the paragraph “HOW TO REMOVE THE FABRIC COVER”. WARNING: Before using the product in the stroller version, always check that the backrest is fitted into the correct position. HOW TO REMOV E THE BACKREST This stroller has a 5-point safety harness that features two shoulder straps, a waist strap and a crotch strap with buckle. WARNING: When using the safety harness with children from birth up to approximately 6 months of age, it is necessary to first fit the shoulder straps through the two adjustment holes on the fabric backrest. Insert the shoulder straps through the appropriate holes in the fabric backrest (diag. 18 A) and check that the shoulder straps are adjusted at the correct height for your child. If they are not at the correct height, adjust them as required (diag. After sitting the child in the stroller, insert the 2 prongs into the buckle and, if necessary, adjust the width of the waist belt operating the buckles (diag. To ensure maximum safety, the stroller has “D” rings to allow you to fasten an additional safety harness approved to BS 6684 regulation. The rings are located inside the stroller’s seat, on the right and left side, as shown in diagram 20. To unfasten the waist strap, press and pull the side prongs at the same time (diag. WARNING: To ensure your child’s safety, it is necessary to always use the safety harness. WARNING: the use of the crotch strap and safety harness is necessary to guarantee the safety of your child. To adjust the inclination of the backrest, press the button located on the backrest. Release the button to lock the backrest in the nearest position. [. . . ] Fit the rain cover, as shown in diagram 37. After use, if the rain cover is wet, let it dry in the air before folding the rain cover to store it. WARNING: Be extremely careful when using the rain cover. WARNING: Do not use the rain cover if the stroller is not fitted with hood or sun-canopy to prevent the risk of suffocation. [. . . ]