User manual CHICCO TRIO I-MOVE TOP

[. . . ] € WARNING: children should be harnessed in at all times and should never be left unattended • WARNING: keep children away from all moving parts whilst you adjust the stroller. € WARNING: The child should be clear of moving parts while making adjustements. € This vehicle requires regular maintenance by the user • Overloading, incorrect folding and the use of non-approved accessories may damage or break this vehicle. € WARNING: It may be dangerous to leave your child unattended • WARNING: before assembly, check that neither the product nor any of its components have been damaged during transportation; if this is the case, do not use the product and keep it out of the reach of children. [. . . ] Never leave the stroller on a sloping surface with a child inside, even with the parking brake ON. The stroller can be used in either parent-facing or front-facing mode. The stroller can be switched from one user mode to another by: Use a soft cloth to clean the plastic parts on a regular basis. Always dry any metal parts that come into contact with water to prevent the formation of rust. MAINTENANCE Lubricate the moving parts, if necessary, with a dry silicon oil. Periodically check the condition of the wheels and keep them clean of dust, dirt and sand. Make sure all plastic parts that slide along the metal tubes are clean and free from dust, dirt and sand; this will avoid friction that may prevent the stroller from working properly. OPENING THE STROLLER WARNING: when opening the stroller, make sure that your child and all other children are at a safe distance. Ensure that during these operations the moving parts of the stroller do not come into contact with your child. 13D parent-facing) ROTATING THE SEAT WARNING: When performing the operations illustrated below, always place the stroller on a flat even surface and remove any weights attached to the handlebar to avoid compromising its stability. To switch from parent-facing mode to front-facing mode, or vice-versa, apply the brakes and proceed as follows: 14. Release both snap-clasps on the handle simultaneously, and move the hand grip section upwards, as seen in diagram 14. Use your foot to release the rotation lock pedal as seen in diagram 15. The seat can now be rotated in either direction (diag. Select the user mode (parent-facing or front-facing) and pull the handlebar back towards you (diagram 16B). INVERTING THE HANDLEBAR The user mode can also be switched by simply inverting the handlebar. Release both snap-clasps on the handle and move the hand grip section to the opposite side until it locks in place (diagram 17). WARNING: when the stroller is used in this user mode, the swivel wheel option must be blocked (see “swivel wheels” paragraph) WARNING: the stroller may become slightly less easy to manoeuvre when used in this mode. Pull the button (A) on the stroller backrest to recline it to the position you need (diagram 18). Release the button and the backrest will click into the closest lock position. Simply push the backrest upwards to raise it again. WARNING: these operations can become more difficult when the child is sat in the seat. [. . . ] RAINCOVER A raincover can also be fitted onto the stroller. Fit the raincover by fastening it to the hood using the elasticated section at the top (diag 44A) and fix in place attaching the Velcro fasteners to the ends of the front frame tubes, as illustrated in 44B. When you have finished using it, allow it to dry properly (if it is wet) before you fold it away. WARNING: pay particular attention when using the raincover. [. . . ]