User manual CHICCO TRIO LIVING SMART

[. . . ] € WARNING: Ensure that all the locking devices are engaged before use • WARNING: To avoid injury ensure that your child is kept away when unfolding and folding this product. € WARNING: Do not let your child play with this product • WARNING: Always use the restraint system. € WARNING: This product is not suitable for running or skating. € WARNING: Check that the pram body or seat unit or car seat attachment devices are correctly engaged before use • The stroller is intended for use with children aged between 0 and 36 months, up to 15 kg of weighting • It is recommended that the backrest should be used in its most reclined position for children from birth to 6 months of age. [. . . ] To fit the seat in the front-facing position, open the seat and, using the orange arrows on the seat as reference (diagram 15 A) slide it onto the hooks (diagram 15 B and C) found on the stroller structure as seen in diagram 15 D. Press the seat downwards (fig 16A) until you hear it click and lock into place (fig 16B). WARNING: Check that the pram body or seat unit attachment devices are correctly engaged before use. REMOVING THE SEAT It is not necessary to remove the stroller lining to remove the seat. Press the orange button on the back of the backrest and lift the seat upwards (diagram 17). Press the grey button on the stroller backrest to adjust the inclination until you find the position you need (diagram 18). Release the button and the backrest will click into the closest lock position. Simply push the backrest upwards to raise it. WARNING: these operations can become more difficult when the child is sat in the seat. Press the two buttons on the inside of the leg rest side fixture (diagram 19) to adjust the leg rest to the required position. To remove the bumper bar, press the two buttons found under the armrests (diagram 20) and pull the bar towards you. Open one side of the bumper bar only to seat the child in the stroller more easily. WARNING: Always restrain the child using the safety harness The bumper bar is NOT a child restraint device. WARNING: Never use the bumper bar to lift the stroller up with the child sitting in it. eRGONOMIC HANDGRIP ADJUSTABLE DOUBLE TWIST 21. Press the button on the handgrip to rotate the handgrip into the required position, according to the height and position most suited to the user (diagram 21). The handgrip can be adjusted to 8 different positions. WARNING: when using the stroller, the handgrips must not be in the DOWN position (diagram 22 A). Make sure that the handgrips are locked in the UP position, as seen in diagram 22 B. PARKING BRAKE The parking brake is applied to both rear wheel at the same time. To make it easier to use the stroller, a special STOP & GO braking system has been installed, indicated by the coloured stickers on the rear brake lever. To put on the brakes, press the right lever downwards (diagram 23). [. . . ] The leg cover can be used in two different modes (section 46 and 47). Thread the top part of the leg cover under the bumper bar and fasten in the highest position inserting the buttons into the slots on the side wings of the seat (diagram 44 B). The leg cover can be folded back over the bumper bar and buttoned in place using the slots, as seen in diagram 47. To fit the basket onto the stroller, connect the clasps A on the basket to the two hooks on the front section of the stroller, and connect the 4 rings to the relative hooks B (diagram 48). [. . . ]