User manual CHICCO URBAN

[. . . ] WARNING: Ensure that all the locking devices are engaged before use. ⷠWARNING: To avoid injury ensure that your child is kept away when unfolding and folding this product. ⷠWARNING: Do not let your child play with this product. ⷠWARNING: Check that the pram body or seat unit or car seat attachment devices are correctly engaged before use. [. . . ] To complete the assembly, thread the straps located on the front part of the basket through the ‘’D’’shaped rings located on the front legs of the stroller, securing the straps with the press stud buttons (fig. WARNING: Do not load the basket with weights exceeding 3 kg. To assemble the seat, position the metal support located on the base of the seat as shown in fig. Then close the zip located at the bottom of the seat, wrapping the metal component (fig. Fasten buckle A located externally in the seat’s foot area, as shown in Fig. 7, then fasten buckle B positioned externally under the seat (fig. 7A) and tension the belt acting as shown in Fig. To attach the seat, introduce the two hooks shown in Fig. 8 in the relative slots located inside the circular articulated joints of the stroller (fig. The seat can be assembled on the stroller in both directions: in forward facing configuration (Fig. To remove the seat, press the grey side buttons and pull upward (fig. These operations must not be performed when the child is inside the seat. WARNING: Do not remove the seat from the stroller when the child is inside of it. SEAT ADJUSTMENTS Once the seat is assembled on the frame, it can be adjusted in three different positions. The entire seat can be adjusted by pressing simultaneously the buttons located above the central articulated joint (fig. The angle of the backrest can be adjusted compared to the seat, by pressing the clip as shown in fig. It is possible to adjust the leg rest in various positions, by pressing simultaneously the buttons shown in fig. The rings are located inside the stroller’s seat on the right and left side, as shown in (fig. REMOVING THE SAFETY BELTS The safety belts can be removed (to be washed or used in pram configuration). To remove the belts, unfasten the waist belt from the relative ‘’D’’-shaped rings and the shoulder straps from the fabric slots located on the backrest. After removing the safety belts, make sure that the belts are reassembled properly using the anchoring points. To re-assemble the safety belts systems, follow the sequence below carefully: 22. [. . . ] Then wrap the elastic part of the mattress around the tube of the structure in the foot area (fig. Lastly, fasten the press stud buttons positioned on both sides (fig. WARNING: The pram should be used from birth up to 6 months of age WARNING: When the seat is in the pram configuration, it should be fitted onto the stroller facing the parent (Fig. WARNING: Do not remove the pram from the stroller when the child is inside of it. [. . . ]