User manual CHICCO XPACE

[. . . ] PLEASE READ IMMEDIATELY • This child car seat is type approved to “Group1”, i. For the transport of children weighing between 9 and 18 kg (ranging approximately between 9 - 12 months and 3 years of age), and conforms to the European ECE R44/04 Regulation on child restraint systems. € It is also type-approved to “Universal” specifications, meaning that it is approved for installation on most types of car vehicles, to be locked in via a 3-point car seat belt. €Universal” means that it is compatible with most car seats but not with all car seats. [. . . ] Installation instruction label T  uide for inserting the diagonal part of the G car safety belt INTENDED USE OF BOTH THE ITEM AND THE VEHICLE SEAT, RESTRICTIONS AND REQUIREMENTS CAUTION!Please read and observe the following instructions very carefully. They refer to both the child car seat and the vehicle seat. Failure to comply with the instructions herein may affect your child’s safety. € The child car seat is intended for children weighing between 9 kg and 18 kg. € The child car seat may be fitted to the front passenger seat or any rear seat, always in a front-facing position. Never use this child car seat on side-facing or rear-facing car seats (Fig. € The car seat must be fitted with a 3-point static or 3-point retractor safety belt, type approved to UN/ECE Regulation No. According to car accident statistics, the rear seats of a car are generally safer than the front seat: it is therefore recommended to fit the child car seat onto the vehicle’s rear seats. In particular, the central rear seat is the safest, if it is equipped with a 3-point safety harness: in this event, it is recommended to fit the child car seat into the vehicle’s central rear seat. If the child car seat is fitted onto the front seat of the car, it is recommended to push the seat back as much as possible, bearing in mind the comfort of the passenger sitting in the seat directly behind it, and, to then adjust the backrest in the most vertical position. If the car is equipped with a safety belt height adjuster, fix it in the lowest position. Then check that the car seat safety belt adjuster is either in a backward position with respect to the backrest of the car seat (or at least aligned to it)(Fig. If the front seat is equipped with a frontal airbag, it is recommended not to fit the child car seat onto this seat. If you wish to fit the child car seat in any seat protected by airbag, always refer to the vehicle instructions manual. Never install the child car seat on a car seat equipped only with a 2-point horizontal lap belt. The correct safety belt positions are highlighted in red. Both instructions and figures are for the installation of the child car onto the vehicle’s right rear seat. To fit the child car seat in other positions, the operations must still be carried out in the same order. Place the child car seat onto the selected vehicle seat. Check that there are no loose objects between the child car seat and the vehicle seat or between the child car seat and the vehicle door. Recline the child car seat backrest entirely by pulling the lever (O), located under the child car seat, forward towards you (Fig. [. . . ] 26) until the straps and belts fit perfectly to the child’s body. Once the straps and belts have been adjusted, take hold of the shoulder straps and pull downwards. -  elease the restraint harness, pressing the red r button on the buckle (Diag. -  pen the fabric cover velcro fastener on the o interior of the backrest (Diag. [. . . ]