User manual CISSELL CF 448

[. . . ] 5 ecito f oto ae Isalto . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ntlain Setting Control Mode Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Setting Up Conveyor Parameters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 8 O e a i gI s r c i n p r t n n t u t o s. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Clears current entry shown on the CURRENT POSITION/ENTRY display if pressed by itself or if pressed with the SHIFT key, clears the memory of all positions previously entered. Initiates or continues after a PAUSE, the search opera- 10. Loads a position into memory after it had been entered on the keyboard. Interrupts the search operation (restart by pressing NEXT). The NEXT DESIRED POSITION DISPLAY will flash to indicate if the conveyor is in the paused state. Used to enter numeric information. Page 6 INSTALLATION 1. Route the connection cable (C2102, supplied with control) between the Conveyor control and the electrical box near the drive on the conveyor. The end with the large connector mounts to the conveyor control. Remove the bottom from the conveyor control and install the connector into the socket on the processor board. Tighten the screws on the plug that attaches it to the socket to prevent it from coming loose. Install the cable bushing into the slot at the rear of the control enclosure and tighten. * Run Conveyor to get #1 position to the desired location, then; press Power On button to turn on. Press Shift and #9 and hold until unit stops changing. Press CLR Page 8 # 1 Enter # of positions on Conveyor (500 = 50 links). # 3 Press 1 and Enter. NOTE: With power removed, the parameters will be retained for approximately 100 hours. Should the power be off for a longer period of time, the parameters will have to be re-entered. CURRENT POSITION To "calibrate" the conveyor control to set the current conveyor position at the uploading point, key in the current position and press SHIFT + SET. The top display should now show the position that is at the unloading point. CUSTOMIZING KEYS SHIFT+1 SHIFT+2 SHIFT+3 SHIFT+4 SHIFT+8 . . Turns "beep" on Turns "beep" off Selects "shortest route" option Selects "pick as entered" option Displays software version (SHIFT-CLR cancels) Page 9 OPERATING INSTRUCTIONS Before operating the conveyor, the conveyor parameters must be entered into the control and the "current position" set. See "SETTING UP THE CONVEYOR PARAMETERS" on page 7. To automatically seek positions on the conveyor, enter the desired position on the keyboard (it will show on the upper display). [. . . ] The conveyor can be operated manually by pressing and holding down one of the JOG buttons. The conveyor will run only while the button is depressed. When the button is released, the conveyor will stop. The JOG buttons are disabled when the conveyor is seeking a position. [. . . ]