User manual CISSELL GEARCAB

[. . . ] No defective equipment or part may be returned to Cissell for repair or replacement without prior written authorization from Cissell. Charges for unauthorized repairs will not be accepted or paid by Cissell. CISSELL MAKES NO OTHER EXPRESSED OR IMPLIED WARRANTY, STATUTORY OR OTHERWISE, CONCERNING THE EQUIPMENT OR PARTS INCLUDING, WITHOUT LIMITATION, A WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, OR A WARRANTY OF MERCHANTABILITY. THE WARRANTIES GIVEN ABOVE ARE EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED. [. . . ] Press STOP again to cancel the cycle. Page 6 DIAGNOSTIC MICROPROCESSOR CONTROL - FEATURES 3. 0 DIP Switch Settings The DMP has an 8-position DIP switch bank that is accessible from the back of the control board. By switching these DIP switches, it is possible for the operator to customize the display and some of the operating features of the dryer. Factory Settings Switch # 1 2 3 4 5 6 7 Function Gear Cabinet Temperature Units Not Used Not Used Not Used Buzzer Timer Not Used OPL OFF OFF ON ON ON ON ON 8 Programming OFF #1 Gear cabinet. #2 Temperature Units: Selects °F or °C for the temperature display. #6 Buzzer Time: This Dip switch determines the length of time that the end of cycle buzzer will remain on. OFF indicates that the buzzer will sound for 5 seconds when the drying cycle is completed. ON indicates that the buzzer will sound continuously until the STOP button is pressed. #8 Programming: This switch enables or disables the programming feature. Page 7 DIAGNOSTIC MICROPROCESSOR CONTROL - FEATURES 4. 0 Programming Set Dip Switch #8 to the ON position. Select the desired program number to change. Set the temperature with the UP/DOWN arrows. Press and hold the PROGRAM button about 3 seconds until the LED stops flashing. The selected program number is now programmed. If the PROGRAM button is pressed for less than 3 seconds, the controller will cancel the program and display the next programs settings. If not programmed correctly, the display will flash E2F for 4 seconds, and the default settings will be used. Follow steps 4. 2 through 4. 7 to re-program any program number. When finished, set DIP Switch #8 to OFF. 4. 7 During the program mode, if the UP/DOWN arrows, REV, or DISPLAY button is not pressed within 10 seconds the default program settings will be used. 5. 0 Temporary Re-Programming of Current Programs (OPL only) 5. 1 The Drying Time, Cooling Time, Temperature, and Reversing Mode of a program currently in use may be modified simply by adjusting any or all of the program parameters for that program, as needed. Once a modification has been made the current program LED will flash indicating that it has been modified. 5. 2 Use the UP/DOWN arrows to adjust program time. 5. 3 Use the Display Select button to choose between Drying Time, Cooling Time, and Temperature. Then use the UP/DOWN arrows to adjust the times and temperature. [. . . ] This button toggles through the five user programmable programs. Holding this button will save a program. Illumination shows which user program is currently being displayed. Page 9 INSTALLATION INSTRUCTIONS UNCRATING Step #1 Uncrate the machine very carefully and check for concealed damage. If any damage caused by shipping is found, it should be reported to the transportation company and a claim filed by you. [. . . ]