User manual CISSELL LOWBOYMAN44

[. . . ] Connect iron cord (5) to Low Boy (8) electrical box as illustrated on following page. Page 2 OVERALL VIEW PARTS Ref. J17 LB7 GSB145 J1 J42 S05 K382 PIU23 Description S Hook Support Spring Hose Support Clamp Hose Cord Spring Clip (3 required) Hose Clamp (2 required) Steam Hose (5 ft. ) Cord Assembly Iron Rest Steam Electric Iron (See attached) Low Boy (See attached) Page 3 TYPE D LOW BOY ASSEMBLY FOR CISSELL STEAM-ELECTRIC IRON WITH ELECTRIC THUMB SWITCH LB148 Solenoid Lowboy Valve 120V. 1-21 Support Rod and Hose Assembly - LB105 Consists of Ref. [. . . ] L B 1 . . . . . . . . . . . . . . . Blank Face Plate 6-32 x 1/2 O. Screw #6-32 Hex Nut #6-32 x 3/8 Screw #6 I. Label Heyco Bushing Cup Washer Green Ground Screw 1/2 Close Nipple Condenser Assy. 50/60 Cy. ) Not Illustrated Page 4 INSTALLATION SET UP: Set unit in position and fasten securely to board. Slip support spring in position and fasten with set screw. IMPORTANT: Before making steam return connections to unit, make steam supply connections. Remove all drain plugs, open steam supply globe valve to steam-flush any borings, grindings or foreign matter that may be clinging within casting or pipes. Close globe valve; replace drain plugs and make steam return connections. Before attaching steam hose from steam-electric iron to solenoid valve, with steam pressure on unit operate thumb switch several times to remove loose particles of scale dirt, which may become embedded in valve seat. Then fasten steam hose to solenoid valve. STEAM SUPPLY: Steam supply connection must fall towards machine (without water pockets). Make connection with 12 or more riser out of steam supply line with union and globe valve. (NOTE: If machine is on the end of a line of equipment, then extend steam header line at least four feet beyond machine. Install check valve and trap at end of line. If gravity return omit trap. ) STEAM RETURN: If steam is returned to atmosphere or sewer, make steam return connection with union, globe valve, check valve and trap with drain. If steam is gravity returned to boiler, omit trap, but install trap as close to floor and as near machine as possible. Inspect traps carefully for inlet and outlet marks and install according to factory instruction. BLOW SCALE AND DIRT FROM STEAM LINES BEFORE INSTALLING TRAP TO INSURE PROPER OPERATION. ) WIRING: Check Voltage and current of solenoid valve and see that they correspond with power line before making installation. [. . . ] Wait until iron becomes hot then push electric thumb switch of iron to allow steam to flow from soleplate of iron. Release thumb switch to stop steam flow. Screw valve knob in for less steam, out for more. MECHANICAL MAINTENANCE To replace coil in solenoid valve, remove bolt, cover, leaf spring, insulating washer and coil. [. . . ]