User manual CISSELL MANHD30ST

[. . . ] STACK LAUNDRY DRYER Gas: Natural and LP Steam Electric Technical specifications Installation instructions Operating instructions Maintenance HD30ST MANHD30ST Cissell Manufacturing Co. 831 S. - 40232-2270 Tel: (502) 587-1292 - Fax: (502) 585-2333 Sales Fax: (502) 585-3625 - Service/Parts Fax: (502) 681-1275 THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER 05/02 IMPORTANT NOTICESPLEASE READ For optimum efficiency and safety, we recommend that you read the Manual before operating the equipment. Store this manual in a file or binder and keep for future reference. WARNING: Purchaser must post the following notice in a prominent location: WARNING: For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death. [. . . ] Use 45° and 30° elbows wherever possible. Use 2 feet (0. 6 m) of straight duct on dryer before installing an elbow on energy-saver models only. Do not install wire mesh or other restrictions in the exhaust duct. Use clean-outs in the exhaust duct and clean periodically when needed. Examine the exhaust system at least once every three months, and more frequently if indicated. Never exceed 0. 3 inches water column (. 75 mbar) static pressure in the exhaust duct. Inside surface of the duct must be smooth. Provide opening to the out-of-doors in accordance with the following: For each dryer 6 inches (153 mm) diameter exhaust requires a 1 square feet (0. 1 m²) opening for make-up air. 8 inches (204 mm) diameter exhaust requires a 2 square feet (0. 2 m2) opening for make-up air. 12 inches (305 mm) diameter exhaust requires a 4 square feet (0. 4 m2) opening for make-up air. Use barometric shutters in the inlet air opening to control air when dryers are not running. Other Recommendations To assure compliance, consult local building code requirements. Troubleshooting Hot dryer surfaces, scorched clothes, slow drying, lint accumulations, or air switch malfunction are indicators of exhaust duct and/or make-up air problems. EXHAUST DUCT MAKE-UP AIR OTHER RECOMMENDATIONS TROUBLESHOOTING Page 21 Rules for Safe Operation of Dryer RULES FOR SAFE OPERATION OF DRYER 1. Be sure your dryer is installed properly in accordance with the recommended instructions. CAUTION Be safeshut main electrical power supply and gas supply off externally before attempting service. CAUTION Never use drycleaning solvents: gasoline, kerosene, or other flammable liquids in the dryer. Never put fabrics treated with these liquids into the dryer. Never use heat to dry items that contain plastic, foam or sponge rubber, or rags coated with oils, waxes or paints. The heat may damage the material or create a fire hazard. Rubber easily oxidizes, causing excessive heat and possible fire. Never let children play near or operate the dryer. Serious injury will occur if a child should crawl inside and the dryer is turned on. [. . . ] No. Part No. Description TUD0505 COMPLETE ASSEMBLY (UPPER) TUD0506 COMPLETE ASSEMBLY (LOWER) 1 2 3 4 5 6 7 8 M270 TU12253 TU14404 TU14451 TU14406 TU3400 TUD0336 TUD0367 TUD0452 TUD0453 #6 LOCK WASHER STUD, #6-32 CONTROL (DMP) OVERLAY, DMP COIN (UPPER) OVERLAY, DMP COIN (LOWER) NUT, #6-32 COIN DROP, 25 C. #5-40 NUT ASM, DMPC PANEL W/A (UPPER) ASM, DMPC PANEL W/A (LOWER) Page 43 DMP CONTROL -OPL Ref. No. Part No. Description TUD0509 COMPLETE ASSEMBLY (UPPER) TUD0510 COMPLETE ASSEMBLY (LOWER) 1 2 3 4 5 6 TU12253 TU14404 M270 TU3400 TU15185 TU15184 TUD0458BLK TUD0459BLK STUD #6-32 DMP CONTROL #6 LOCK WASHER NUT, #6-32 OVERLAY, DMP OPL (UPPER) OVERLAY, DMP OPL (LOWER) LFT DMP PANEL W/A (UPPER) RHT DMP PANEL W/A (LOWER) Page 44 MECHANICAL COIN - CONTROL Ref. No. Part No. Description TUD0503 COMPLETE ASSEMBLY (UPPER) TUD0504 COMPLETE ASSEMBLY (LOWER) 1 2 3 4 5 6 7 8 CM7366 EA-00619-0 TUD0354 TUD0355 TUT316 TU4958 P104 TU3266 TUD0348BLK TUD0349BLK COIN METER 24V, 25 C. [. . . ]