User manual CISSELL SFBMAN99

[. . . ] Steam Finishing Board Model A OWNERS MANUAL CISSELL MANUFACTURING COMPANY HEADQUARTERS 831 SOUTH FIRST ST. BOX 32270 LOUISVILLE, KY 40232-2270 PHONE: (502) 587-1292 SALES FAX: (502) 585-3625 SERVICE/PARTS FAX: (502) 681-1275 THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER. MAN99 39 /8 Page 1 WARRANTY The Cissell Manufacturing Company (Cissell) warrants all new equipment (and the original parts thereof) to be free from defects in material or workmanship for a period of one (1) year from the date of sale thereof to an original purchaser for use, except as hereinafter provided. With respect to non-durable parts normally requiring replacement in less than one (1) year due to normal wear and tear, including, but not limited to, cloth goods, valve discs, hoses, and iron cords, and with respect to all new repair or replacement parts for Cissell equipment for which the one (1) year warranty period has expired, or for all new repair or replacement parts for equipment other than Cissell equipment, the warranty period is limited to ninety (90) days from date of sale. [. . . ] Slip support spring in position and fasten with set screw. IMPORTANT: Before making steam return connections to unit, make steam supply connections. Remove all drain plugs, open steam supply globe valve to steam-flush any borings, grindings or foreign matter that may be clinging within casting or pipes. Close globe valve; replace drain plugs and make steam return connections. Before attaching steam hose from steam-electric iron to solenoid valve, with steam pressure on unit operate thumb switch several times to remove loose particles of scale or dirt, whick may become embedded in valve seat. Then fasten steam hose to solenoid valve. STEAM SUPPLY: Steam supply connection must fall towards machine (without water packets). Make connection with 12 or more riser out of steam supply line with union and globe valve. (NOTE: If machine is on the end of a line of equipment, then extend steam header line at least four feet beyond machine. Install check valve and trap at end of line. If gravity return omit trap. ) STEAM RETURN: If steam is returned to atmosphere or sewer, make steam return connection with union, globe valve, check valve and trap with drain. If steam is gravity returned to boiler, omit trap, but install check valve in return line near machine. (NOTE: For successful operation of machine, install trap as close to floor and as near machine as possible. Inspect traps carefully for inlet and outlet marks and install according to factory instruction. BLOW SCALE AND DIRT FROM STEAM LINES BEFORE INSTALLING TRAP TO INSURE PROPER OPERATION. ) WIRING: Check Voltage and current of solenoid valve MECHANICAL SPECIFICATIONS and see that they correspond with power line before making installation. Use irons with properly rated Boiler Horsepower - Approximately 1/8. NOTE: Connect power supply to terminals in electric box as per wiring diagram in accordance with electric code in your area. FOR THREE PHASE CURRENT: Connect two wires from three phase supply to two Power Connections of outlet box. IMPORTANT: Connect ground wire as shown and check all wiring before closing switch. IMPORTANT Operating Steam Pressure - 5 to 100 lbs. Steam Return - 1/2 Pipe Connection. Attach Steam Hose to Steam Tube as illustrated. Push Steam Hose down on Steam Tube just far enough beyond swedge to allow Hose clamp connection. [. . . ] If spring and disc are satisfactory, seat in valve body may be damaged or valve stem bent. Defective parts must be replaced to secure proper operation. When major repairs are required, install a Cissell Replacement Valve. Exhaust steam from chamber, then remove valve. [. . . ]