User manual CITIZEN WATCH 374

[. . . ] CITIZEN QUARTZ ANALOG DEPTH METER WITH CHRONOGRAPH Model No. 374 · INSTRUCTION MANUAL CTZ-B6757 Two models of this watch are available: one with depth readings indicated in metres (m), the other with readings indicated in feet (ft). Diving with this watch Diving can be a safe, enjoyable activity when diving rules are properly followed. It is always, however, accompanied by certain risks including diver's paralysis and unanticipated accidents. [. . . ] Rather, flush out such debris using fresh water. If this fails, consult a Citizen Service Centre. For general repairs and maintenance please refer to "Care for long term use". Chronograph Mode Switching from the Time Mode to the Chronograph by pressing button 1 once. A maximum of 50 minutes may be measured by the chronograph. After 50 minutes (1/20 second = 0. 05 second increments) measurement will stop automatically and chronograph will return to the reset position. The chronograph 1/20 second hand will move fir 30 seconds, after which it will be displayed when chronograph measurement is stopped. The chronograph display Please refer to the fold-out watch display located on the opening page of this manual. [After the battery is replaced or if the hands are in the wrong position] USE the following ALL RESET operation to adjust the position of the hands if: In the Time Mode The function hand A does not point to EXIT. In the Diving Mode The function hand A does not point to 0. In the Chronograph Mode The chronograph minute hand B does not point to 0. The chronograph second hand A does not point to 0. The chronograph 1/20 second hand F does not point to 0. The display is abnormal in any other way. [Using ALL RESET and Adjusting the position of the hands. ] 1. Unscrew the crown to release it, pull it out two steps. Simultaneously press 1 and button 2 and then release them. ALL RESET is complete if the function hand moves slightly. Pressing button 2 will allow the mode hand B and the function hand A to move simultaneously. Move the two hands forward rapidly by pressing button 2 continuously. Align the second hand F to the 0 position by pressing button 1 . Move it forward rapidly by pressing button 2 continuously. Refer to page 12 for instructions on setting the time and date. [. . . ] Be sure the crown is completely pushed in prior to any contact with moisture. If your model is equipped with a screw down crown, be sure it is properly seated against the case. Do not operate the crown or any push button when the watch is wet as this may allow the entrance of moisture. If at anytime, you notice moisture in your timepiece that does not clear in a short period of time, you should send your timepiece as soon as possible to the nearest Authorized Service Center for inspection. [. . . ]