User manual CITIZEN WATCH B080

[. . . ] Since it takes time to recharge the watch until it starts running again once it has stopped, try to make sure the watch is charged everyday. If the watch has stopped running, expose it to intense light such as sunlight to recharge. When recharging using light of low illuminance of 3, 000 lx or less, pull out the crown before charging. After charging, always make sure to correctly set the time and return the crown to the normal position before using the watch. [. . . ] (eg) Charging the watch near a light source that easily becomes hot, such as an incandescent lamp or a halogen lamp. Charging in a place that easily becomes hot, such as a dashboard. When you charge the watch by an incandescent lamp, take a distance about 50cm (20in. ) from the light source to prevent extremely high temperature. 8 9 F. TIME REQUIRED FOR CHARGING Time required for recharging may vary according to the design and operating environment. The following table will serve as a rough reference. Charging time Environment Inside an ordinary office 60-70cm (24-28in. ) under a fluorescent light (30W) 20cm (8in. ) under a fluorescent light (30W) When recharging using light of low illuminance of 3, 000 lx or less, pull out the crown before charging. Figures in parentheses in the table indicate charging times with the crown pulled out. * The recharging time is the time when the watch is continuously exposed to light. The time to fully recharge after the watch has stopped. The time required for the watch to run for one day with one second interval movement Illuminance (lux) 500 1, 000 3, 000 10, 000 100, 000 One day usage 3 hours 30 minutes 2 hours 40 minutes 10 minutes 2 minutes From the stop state to one second movement Full charge time (570 hours) (300 hours) (100 hours) 30 hours 6 hours (60 hours) (30 hours) (9 hours 30 minutes) 3 hours 30 minutes 1 hour Outdoors, cloudy Outdoors, summer, sunny 10 11 G. PRECAUTIONS CAUTION: Water-resistance performance There are several types of water-resistant watches, as shown in the following table. Indication Specifications Minor exposure to water (washing face, rain, etc. ) For correct use within the design limits of the watch, confirm the level of waterresistance of your watch, as indicated on the dial and case, and consult the table. Examples of use Dial Case (case back) Moderate exposure to water (washing, kitchen work, swimming, etc. ) Marine sports (skin diving) Scuba diving (with air tank) Operation of the crown with moisture visible WATER RESIST or no indication WR 50 or WATER RESIST 50 WR 100/200 or WATER RESIST 100/200 WATER RESIST(ANT) WATER RESIST(ANT) 5 bar or WATER RESIST(ANT) WATER RESIST(ANT) 10bar/20 bar or WATER RESIST(ANT) Water-resistant to 3 atmospheres Water-resistant to 5 atmospheres Water-resistant to 10/ 20 atmospheres OK OK OK NO OK OK NO NO OK NO NO NO NO NO NO 12 The unit "bar" is roughly equal to 1 atmosphere. WATER RESIST(ANT) MM bar may also be indicated as W. R. MM bar 13 · Water-resistance for daily use (to 3 atmospheres): This type of watch is water-resistant to minor exposure to water. For example, you may wear the watch while washing your face; however, it is not designed for use underwater. · Upgraded water-resistance for daily use (to 5 atmospheres): This type of watch is water-resistant to moderate exposure to water. You may wear the watch while swimming; however, it is not designed for use while skin diving. · Upgraded water-resistance for daily use (to 10/20 atmospheres): This type of watch may be used for skin diving; however, it is not designed for scuba or saturated diving using helium gas. CAUTION · Be sure to use the watch with the crown pressed in (normal position). If your watch has a screw-type crown, be sure to tighten the crown completely. · Do NOT operate the crown with wet fingers or when the watch is wet. Water may enter the watch and compromise water-resistance. · If the watch is used in seawater, rinse with fresh water afterward and wipe with a dry cloth. · If moisture has entered the watch, or if the inside of the crystal is fogged up and does not become clear within a day, immediately take the watch to your dealer or Citizen Service Center for repair. Leaving the watch in such a state will allow corrosion to form inside. · If seawater enters the watch, place the watch in a box or plastic bag and immediately take it in for repair. [. . . ] Periodical inspections Your watch needs inspection once in every two or three years for safety and long use. To keep your watch water-resistant, the packing needs to be replaced regularly. Other parts need to be inspected and replaced if necessary. Ask for Citizen geuine parts upon replacement. 16 17 H. [. . . ]