User manual CITIZEN CALIBER NO 0855

[. . . ] Setting Instructions for Movement Caliber 0855 Contents 1) 2) 3) 4) 5) 6) 7) 8) (click on a topic) Outline Specifications Before Using Special Functions of the Solar Powered Watch Notes on Use Notes on Recharging Time Required for Recharging Using Your Watch a. Insufficient Charge and Time Setting Warnings f. Checking and Adjusting the `0' Position for the Hands 9) Care of Your Timepiece Return to Table of Contents 1. Outline This is a multi-hand, multi-function analog solar and chronograph functions. [. . . ] If all the buttons are pressed simultaneously, "O" Position Adjustment (page 10) and all other functions will need to be set again. 3) USING THE ALARM The alarm sounds once a day for 15 seconds at the alarm time set. Pressing any of buttons (A), (B) or (C) stops the alarm ringing. Setting the alarm Alarm setting is on a 24-hour system in 1 minute. The hands are moved thus: minute hand -> hour hand -> 24hour hand. 1)Press button (M) to set the mode hand to <ALM> and switch to the alarm mode. 2)Pull button (M) out to the alarm set time adjusting state. 3)Press buttons (B)or (C) to set the minute, hour and 24-hour hands to the desired time. · · Each time button (B) is pressed . . . The watch advances 1 minute in a clockwise direction Each time button (P is pressed . . . The watch turns back in 1 minute increments in a counter clockwise direction Return to Table of Contents Return to Table of Contents Depress button (B) or (C) continuously, the hands move rapidly. After setting the alarm time, push the (M) button. The hour, minute and 24hour hands move rapidly automatically to the present time. If those hands do not stop moving, push the (M) button again. Switching the alarm ON and OFF Each time button (A) is pressed in the alarm mode, the alarm switches ON and OFF Alarm sound monitor On the alarm mode (button (M) in the normal position), press button (A) and the alarm will sound for 5 seconds. Note * There may be some variation in the volume of the alarm sound, depending on how much the Eco Drive Rechargeable battery is charged. * The alarm sound volume gets rather lower in the display other than the time display (alarm, chronograph, "O" position confirmation, and each display's adjustment state). Once the alarm time has been set, use the watch normally in time display mode. 4) USING THE CHRONOGRAPH Chronograph measurement is taken in 1/20 (0. 05) seconds and can continue for 60 minutes max. Over 60 minutes, the watch enters the chronographreset state. Chronograph measurement Chronograph reset Read the chronograph hands For measurement less than 1 minute Second hand -> Chronograph second hand Function hand -> Chronograph 1/20 second hand For measurement over 1, minute: Second hand -> Chronograph second hand Function hand -> Chronograph minute hand Return to Table of Contents Return to Table of Contents Chronograph measurement Chronograph standard or accumulated elapsed time measurement. 1) Press button (M) to set the mode hand <CHR> and get the chronograph display. At this time, the second hand and the function hand will return to the "O" position. The hour, minute, and 24-hour hands show the present time. [. . . ] HANDLING OF WATER-RESISTANT WATCHES Although water-resistant watches are warranted, steps should be taken to avoid damage that may result from accidents or mishandling: Do not operate the crown or push-button in the water or while the watch is wet. Should the watch become immersed in water, dry it off right away. If the watch comes in contact with salt water, be sure to rinse it thoroughly in warm fresh water to remove any trace of salt. If a watch is wet from cleaning or by accident, never store it in a closed container. [. . . ]