User manual CITIZEN CALIBER NO 1002

[. . . ] To achieve optimal precision when setting the minute hand, move the minute hand four to five minutes past and then back to the desired setting. For calendar-equipped watches, do not confuse AM and PM settings. For watches equipped with locking screw-type crowns, do not forget to return the crown to the locked position after setting watch. Setting the calendar (1) Pull out crown to position 1 (2) Set date by turning crown to the left. [. . . ] The foregoing manner of cleaning should not be done if the watch is not water-resistant but should instead be done by your jeweler. CARE FOR STRAPS LEATHER Heavy perspiration, if not removed from a leather strap, can wash out the natural oils and cause the leather to become dry and deteriorate. Any moisture should be blotted with a soft dry cloth or paper towel and the strap allowed to dry naturally. Salt residue and soil can be removed from the leather by cleaning with a dampened soft cloth and mild soap or saddle soap. Occasionally, the inside surface of the strap should be cleaned by using a soft cloth dampened with alcohol. The strap should always be worn a little loosely (one finger space between wrist and strap) to allow air to circulate thus causing any moisture to evaporate. RUBBER Rubber straps should be washed frequently with mild soap and warm water using a soft brush. Thorough cleaning, using the same method, should especially be done after use in salt water. Solvents, oils, perspiration, tanning lotion and salt can cause rubber to deteriorate if not removed. Marking on the Dial Marking on the Caseback Face washing, splashes, sweat, raindrops, etc. Swimming Skin diving (diving without air tanks) NO Scuba diving (diving with air tanks) Water-resistant characteristics NONE NONE NO NO NO Non water-resistant watch and must be kept away from water. An ordinary water-resistant watch and can withstand splashes, sweat, rain-drops and etc. It is not specially designed for scuba diving. Usable up to the respective indicated depths. NONE WATER RESIST WATER RESIST OK NO NO NO WR100M WR10bar WR150M OK OK OK NO WR200M WATER RESIST OK OK OK OK See instruction book for further information Water Resistance The water-resistant quality of our timepieces is offered in varying degrees depending on the model. This ranges from non-water resistant models to those suitable for SCUBA diving. Water resistance of our timepieces is measured in BAR or Barometric Pressure. Each BAR of pressure is equal to 14. 5 pounds per square inch of pressure. Water resistance is measured when the watch is at a static, or motionless state. As the watch is moved in water, such as from the motion of swimming, pressure is added from velocity. While you may be swimming in a pool at surface level, the watch may be experiencing forces equal to that of 100 feet of water pressure (3 BAR). Diving into a pool can cause forces on the watch to exceed those pressures. As such, you should always allow a margin of safety when exposing your watch to moisture. Never "push the limit" of the degree of water resistance of your timepiece. A primary factor to keep in mind about water resistance is that periodic maintenance is needed to maintain original factory specifications for water resistance. [. . . ] "Water Resist 20BAR" or "W. R. 20BAR", Dial marked "WR200" This watch is designed to withstand water pressure up to 666 feet. This includes all exposure to water up to and including recreational SCUBA diving. Be sure to rinse the watch with fresh water after exposure to a chlorinated pool, salt water, soaps, etc. [. . . ]