User manual CITIZEN CH-656C

[. . . ] Measurement should be made regularly at the same time each day. · Do NOT be impressed by the results of one measurement. Keep a record of blood pressure variations. · Emotional stress may tend to cause pressure to rise. [. . . ] and a record should be kept of any necessary data. Nature and frequency of maintenance: This products is designed for use over an extended period of time; however, it is generally recommended that it be inspected every two years to ensure proper function and performance. Protect the nature environment: Precautions for maintenance · Do NOT store the blood pressure monitor where it will be exposed to direct sunlight, high temperature (over 60°C), low temperature (below ­20°C), high relative humidity (over 95%) or in a dusty place. · Do NOT expose the blood pressure monitor to under force or vibration, or drop it. · Remove the battery/batteries when not in use for a long period. · Do NOT disassemble the apparatus. · Do NOT bend the cuff or air hose unnecessarily. · NEVER wipe the blood pressure monitor with thinner or benzene, as they may damage it. · When the monitor is very dirty, wipe it clean with a cloth moistened with Sterilizing alcohol or a neutral detergent, and then wipe it with a dry cloth. Please help protect natural environment by respecting national and/or local recycling regulations when disposing of the batteries and the products at the end of their useful lives. - Eng 4 - IDENTIFICATION OF PARTS Diastolic blood pressure/ Pulse display section Systolic blood pressure display section Battry cover English Español Português Italiano M Deutch Power/Start switch Memory recall switch Wrist cuff Français - Eng 5 - BATTERY REPLACEMENT 1. To use this unit, you must install batteries, " will display and also If battery mark " on the display, you must change two pieces of batteries. Replace the new two pieces of batteries, matching the (+) and (­) polarities on each battery with the polarity marks on the case. "LR03" batteries or equivalent is suitable for this blood pressure meter. · Pull the transparent ribbon to remove the batteries. MEASUREMENT PROCEDURES 1. Attaching of wrist cuff The blood pressure is measured at the wrist. Therefore, rolling up the sleeve is no longer necessary. The pressure cuff has integrated into the wristlet. Wind the wristlet around your left wrist. The display is at the inner of the wrist. - Eng 6 - · Apply the wrist cuff to the wrist and make sure it is not too loose or too tight. If the wrist cuff is applied inappropriately, it may display an error or abnormal values. Pull the wrist tight and close the "Burr closure". Wrist circumference: 13. 5-19. 5 cm. Measurement Procedures for People With a Weak Pulse · Apply the middle part of the wrist cuff to the artery in the wrist to measure blood pressure. English Español Português Italiano 2. To start the Measurement Deutch CAUTION Do not grasp the unit too tightly. Keep your left wrist relaxed during measurement period. [. . . ] 1 is always used to store the newest set of results. · If the "Memory recall" switch is pressed further, the old date are indicated in the order of the time series. - Eng 10 - 6. Memory clear function English Español Português Italiano M While the memory datum to be cleared are indicated and when the "Memory recall" switch is continued to push for 3 seconds, buzzer beeps and the memory datum are cleared. Deutch Français - Eng 11 - DESCRIPTION OF DISPLAY MARKS DISPLAY MARK CONDITION / CAUSE The cuff was inflated to more than 280 mmHg. Pressurization is not possible Cuff winding has not been performed correctly. The pulse could not be measured accurately. [. . . ]