User manual CITIZEN CT-S801

[. . . ] En If you want to dispose of this product, do not mix it with general household waste. There is a separate collection systems for used electronics products in accordance with legislation under the WEEE Directive (Directive 2002/96/EC) and is effective only within European Union. This printer conforms to the following Standards: This declaration applies only to the 230-V model. IMPORTANT: This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. [. . . ] Next, connect the AC power cord to the AC inlet, and insert the plug into an electric outlet. AC adapter AC inlet AC power cord Built-in power supply type AC power cord AC adapter type Use only an AC adapter that complies with the specified ratings. Always hold the AC adapter's cable connector by the connector when removing or inserting it. Use an AC power source that does not also supply power to equipment that generates electromagnetic noise. Pulling on the AC power cord may damage it, cause a fire, electric shock, or break a wire. If a lightning storm is approaching, unplug the AC power cord from the electric outlet. a lightning strike may cause a fire or electric shock. Keep the AC power cord away from heat generating appliances. The insulation on the AC power cord may melt and cause a fire or electric shock. If the printer is not going to be used for a long time, unplug the AC power cord from the electric outlet. Place the AC power cord so that people do not trip on it. Ethernet and powered USB interfaces are available as options in addition to those listed here. When disconnecting the cable, always hold the connector. Be careful not to insert the USB interface cable into the cash drawer kick-out connector. To connect more than one printer to a single computer via a USB interface you must change the serial number of the USB interface. Use a serial interface cable with the connection layout shown below. Place the interface cable so people do not trip on it. Confirm the orientation of the cash drawer kick-out cable connector and connect it to the cash drawer kick-out connector at the back of the printer. Screw the cash drawer's ground wire to the body of the printer. Screw for ground wire Connect only the cash drawer kick-out cable connector to the cash drawer kick-out connector. ) Signals cannot be output from the cash drawer kick-out connector while printing. 1 2 3 4 5 6 Signal FG DRAWER1 DRSW VDR DRAWER2 GND Function Frame ground Cash drawer 1 drive signal Cash drawer switch input Cash drawer drive power supply Cash drawer 2 drive signal Signal ground (common ground on circuits) Connector used: TM5RJ3-66 (Hirose) or equivalent Applicable connector: TM3P-66P (Hirose) or equivalent 3 V (3) DRSW signal DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r command or at pin 34 on the parallel interface port. [. . . ] Paper type Recommended paper roll Product name TF50KS-E2D from Nippon Paper PD150R or PD160R from Ohji Paper PA220AG, HP220A, HP220AB-1, F230AA, P220AB, or PB670 (2-color paper) from Mitsubishi Paper Paper width 83 +0 -1 Maximum print area 80 Paper width 80 +0 -1 Maximum print area 72 80 or less Printable side Paper width 60 +0 -1 Maximum print area 48 (Initial setting) Paper width 58 +0 -1 Maximum print area 48 (Initial setting) Paper thickness (µm) Core inner diameter d (mm) Core outer diameter D (mm) 65-75 12 75-150 25. Use paper that is wound as follows: Not creased and fits tight to the core. Memory switches are used to set various printer settings. The memory switches can be set manually (set by hand on the printer) or by commands. [. . . ]