User manual CITIZEN CT915

[. . . ] INSTRUCTION MANUAL FOR CT915 SAFETY PRECAUTIONS WARNING Keep the battery away from infants. If an infant swallowed the battery, meet a doctor immediately. Measure temperature according to directions given by a doctor and consult him (her). CAUTION Do not disassemble the thermometer. Do not splash water over the thermometer. [. . . ] * In the basal body temperature recording mode, the temperature measured for the first time on each day is recorded automatically. English - Eng 11 - * The measure mark indicates how many minutes have passed after measurement is started as shown below. Start of measurement After 1 minute After 2 minutes After 3 minutes After 4 minutes After 5 minutes / Finish of measurement 3. Store the probe in the body 1) Wipe off saliva with tissue paper, etc. 2) Wind the cord clockwise onto the body by 2 turns and a half. 3) Fix the probe to the hook with a click and close the cover. - Eng 12 - 4. Push and hold the POWER/MEASURE switch for a while (about 1 second) to turn off the power. If the POWER/MEASURE switch is not pushed, the record display screen appears automatically and the power is turned off 30 more seconds after. English basal * In the for thebody temperature recording mode, the temperature measured first time on each day is recorded automatically, but the temperatures measured for the second time and after on the same day are not recorded automatically. When recording the temperature measured for the second time or after, push the SET switch while the measurement finish screen is displayed, and the record is rewritten. - Eng 13 - ALL-MEASUREMENTS RECORDING MODE 1. Remove the probe from the body 1) Open the cover and push the rear end of the probe lightly to remove the probe from the hook. 2) Unwound the cord from the body. 2. Measure the body temperature Method of measuring body temperature (Allmeasurements recording mode) 1) Push and hold the POWER/MEASURE switch for a while (about 1 second) to turn on the power. Fix the probe to the hook with a click and close the cover. When the power switch is pressed ON, the display will read as a check that all part of the display is working (Safety test for system). Measurement Screen No display of LADY Measurement mark - Eng 14 - 2) Then, push the POWER/MEASURE switch momentarily to display the measure screen. * If the POWER/MEASURE switch is pushed and held for a while (about 1 second), the power is turned off. When displaying the measure screen while the power is turned on, push and release the POWER/MEASURE switch quickly. * To change the basal body temperature recording mode ( LADY is displayed) to the all-measurements recording display ( LADY is not displayed), repeat the operation of "Setting alarm, time, date, and mode" (on pages 6-10) from the first, then select the all-measurements recording mode. 3) Place the sensor of the probe under your tongue to start measurement. If peeps are heard, the measurement is in error ("E" is displayed). In this case, push the POWER/ MEASURE switch again and start measurement. When more pips are heard about 5 minutes after measurement is started, measurement is finished. * The first electronic pip indicates that the temperature is being measured normally. [. . . ] Store the thermometer in a place where water will not be splashed over it. Do not store the thermometer in a place where it may be badly affected by atmospheric pressure, temperature, humidity, ventilation, sunlight, dust, salt, air containing sulfur, etc. or where chemicals are stored or gas is produced. Protect the thermometer from vibrations and impacts (during transportation, too). [. . . ]