User manual CITIZEN PRINTIVA QUICK GUIDE

[. . . ] It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the user at his own expense will be required to take whatever measures may be necessary to correct the interference. This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus, as set out in the radio interference regulations of the Canadian department of communications. Before using this product, be sure to read through this manual. [. . . ] Always hold the AC adapter's cable connector by the connector when removing or inserting it. Use an AC power source that does not also supply power to equipment that generates electromagnetic noise. Pulling on the AC power cord may damage it, cause a fire, electric shock, or break a wire. If a lightning storm is approaching, unplug the AC power cord from the electric outlet. a lightning strike may cause a fire or electric shock. Keep the AC power cord away from heat generating appliances. The insulation on the AC power cord may melt and cause a fire or electric shock. If the printer is not going to be used for a long time, unplug the AC power cord from the electric outlet. Place the AC power cord so that people do not trip on it. Always unplug the AC adapter from the printer before connecting the printer to a Powered USB interface. failure to do so may damage the host PC. Do not use the printer under the following conditions. locations subject to vibration or instability. Locations where the printer is not level. Set the partition to the width of the paper roll you are loading. the partition is set at the factory to the position shown below. For 3-inch type: 80-mm wide paper roll For 2-inch type: 58-mm wide paper roll, 60-mm wide paper roll (2-sheet partition installed. Press up on the cover open button to open the paper cover. Press in the position shown by the arrow and set the partition in a slot that matches the width of the paper roll you are using. However, to use an 83-mm wide paper roll, remove the partition. Or, when you are using a 60-mm wide paper roll with the 2inch type, remove the partition installed for 58-mm. Make sure the partition is not slanted when setting it for 58-mm or 60-mm paper rolls. [. . . ] Do the settings while confirming the memory switch function and settings on the printout. While the paper cover is open, press and hold the FEED button while turning the power on. Press the FEED button twice and close the paper cover. (The current settings for memory switches 7 to 10 are not printed. [. . . ]