User manual CITIZEN SLD-7008II

[. . . ] Operation of this equipment in a residential area is likely to cause interference, in which case the user at his own expense will be required to take whatever measures may be necessary to correct the interference. This digital apparatus does not exceed the class A limits for radio noise emissions from digital apparatus, as set out in the radio interference regulations of the Canadian department of communications. 1 The information contained herein is subject to change without prior notice. Reproduction of part or all of this document is prohibited without written permission from CBM Corporation. [. . . ] Paper cutter, gears, active electrical parts) while the printer is working. Q If the printer emits smoke, an odd smell, or unusual noise while printing, immediately abort the current print session and unplug the printer from the supply outlet. When cleaning the printer, always turn it off and unplug it from the supply outlet. Use a soft, dry cloth for cleaning the surface of the printer case. For severe stains, use a soft cloth slightly dampened with water. Never use organic cleaning solvent such as alcohol, paint thinner, or benzen. To remove paper chips, use a soft brush. When transporting the printer, remove the roll paper from its paper holder. When cleaning the thermal head surface, use a cotton gauze slightly dampened with alcohol. Do not touch the thermal head's printing surface with bare hand or a metallic implement. The thermal head is at a dangerously high temperature immediately after printing. Every cut paper should be no less than 10 mm in length. Thin paper strips can cause paper to jam. When cutting a label roll, be sure to cut the base sheet. 1 2 3 Turn off the power of the printer. For the AC adapter type only: With the flat side of the AC adapter's cable connector facing upward, insert the cable connector into the power connector on the back side of the printer. Connect the AC power cord to the inlet of the printer, and insert the AC power-cord plug into a suitable wall outlet. 1 2 3 4 Turn off the power of the printer. ENGLISH 1 2 3 Turn off the power of the printer. Orient the drawer kick-out cable connector correctly, insert it into the drawer kick-out connector on the back of the printer. ENGLISH 1 2 3 4 Turn off the power of the printer. Take off two screws and remove printer cover. [. . . ] ) Fin del papel: Cuando se haya agotado el rollo de papel , el sensor del fin del papel , situado cerca de la cabeza impresora en la ruta del papel , detectará el final del rollo del papel , haciendo que se encienda la luz ERROR y se detenga la impresión. (Consulte "Selecting the paper sensor valid for paper end signal output" y "Selecting the Paper-Near End Sensor valid for print stop". Because the status sent from the printer has certain fixed bits, it is possible to identify to which command the status belongs. When using ASB (Automatic Status Back), however, the first byte of ASB should be checked, and then the three consecutive bytes except for XOFF should be treated as ASB data. [. . . ]