Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CLARION K10. We hope that this CLARION K10 user guide will be useful to you.
Lastmanuals help download the user guide CLARION K10.
You may also download the following manuals related to this product:
CLARION K10 INSTALLATION GUIDE (674 ko)
Manual abstract: user guide CLARION K10
Detailed instructions for use are in the User's Guide.
[. . . ] If it becomes necessary to send the product or any defective part to Clarion, the product must be shipped in its original carton or equivalent carton, fully insured, with shipping charges prepaid. Clarion will not assume any responsibility for any loss or damage incurred in shipping. ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES SHALL CLARION CORPORATION BE LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY
i
TO USE OF THE PRODUCT. [. . . ] The horn will honk twice (if connected) and the parking lights will flash twice to confirm disarming of the system. The optional Starter Kill will be deactivated. The status LED will turn off, unless the system is programmed for Passive Mode. In Passive Mode, the status LED will flash rapidly when the system is disarmed. This indicates that the system will re-engage the starter kill and re-lock the doors (if Passive Locking has been programmed) in 30 seconds unless the ignition is turned on.
note: If the system has been armed with the remote, you must use the remote or the Override switch to disarm the system and deactivate the starter kill. Manually unlocking the vehicle does not disarm the system; it will only unlock the doors.
7
disabling the system without a remote
If your remote is lost or damaged, you can manually override the system. To do this, you must have the vehicle's ignition key and know where the Override switch is located. Be sure to check with the installer for the location of the Override switch. To disarm the security system, turn the ignition to the ON position. Press and release the Override switch within 10 seconds. The status LED will stop flashing and the vehicle should start. If the vehicle does not start, you may have waited too long; turn the ignition off and repeat the process. Location of Override Switch _________________________________
DRW-35
silent arm/disarm
To temporarily turn off the arm or disarm chirps, use Silent Arm/Disarm. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you.
8
override mode
You can prevent your system from automatically activating the Starter Kill and locking the doors by using override mode. This is very useful when washing the vehicle or having it serviced. In override mode, the starter kill cannot be activated, even with the remote, but all convenience functions (door locks, trunk release, etc. ) will continue to work normally.
To enter or exit override mode:
1. Press and then release the
DRW-35
Override switch within 10 seconds. The status LED will light steadily if you are entering override mode and will turn off if you are exiting override mode.
panic mode
If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote. Just press for two seconds to enter panic mode. In panic mode, the horn will honk and the parking lights will flash for 30 seconds. To stop panic mode at any time, press on the remote again.
note: In order for panic mode to be effective, the vehicle's horn (or optional siren) as well as the vehicle's parking lights must be connected.
9
individual recognition
Individual recognition is a feature available. [. . . ] The vehicle's horn (if connected) will honk and the parking lights will flash once to confirm arming of the system.
To unlock/disarm using your remote
To disarm the system press for one second. The Starter Kill will be deactivated and the vehicle's horn (if connected) will honk twice and the parking lights will flash twice.
Disabling the Starter Kill without a remote
Turn on the ignition. Press and release the Override switch within 10 seconds. The LED will stop flashing and the vehicle should start.
To enter or exit override mode
Turn the ignition to the ON position. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CLARION K10
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CLARION K10 will begin.