User manual CLARION M455

[. . . ] Owner's manual Mode d'emploi Manual de instrucciones Istruzioni per l'uso M455 MARINE AM/FM/CD MULTIMEDIA CONTROLLER · COMBINÉ NAUTIQUE RADIO AM/FM-LECTEUR CD MULTIMEDIA · CONTROLADOR MULTIMEDIA MARINO DE AM/FM/DISCOS CD · UNITÀ DI CONTROLLO MULTIMEDIALE PER USO MARITTIMO AM/FM/CD Thank you for purchasing this Clarion product. Please read this owner's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it with this manual. [. . . ] To cancel the random play, press the [RDM] button again. Operations Common to Each Mode Setting the clock 1. Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display. Press the [a] or [d] button to select "CLOCK". Press the [a] or [d] button to select the hour or the minute. Turn the [ROTARY] knob to set the correct time. The clock is displayed in 12-hour format. 2. Press the [a] or [d] button to select "SCRN SVR". Turn the [ROTARY] knob to select the setting. Each time you turn the [ROTARY] knob, the setting changes in the following order: OFF SS MESSAGE 5. Press the [ ] button to store the setting. Press the [T] button to return to the previous mode. 6. Press the [ ] button to store the time into memory. Press the [T] button to return to the previous mode. Note: · You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the boat's battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled. Entering MESSAGE INFORMATION Message up to 30 characters long can be stored in memory and displayed for any mode. The factory default setting is "WELCOME TO CLARION". 1. Press and hold the [T] button for 1 second or longer to switch to the adjustment selection display. Press the [a] or [d] button to select "INPUT". Press the [BND] button to clear the old message. Press the [a] or [d] button to move the cursor. Press the [DISP] button to select a character. Each time you press the [DISP] button, the character changes in the following orders: Numbers Symbols Capital letters Numbers. . . Turn the [ROTARY] knob to select the desired character. [. . . ] Sound is bad directly after power is turned on. Source selection does not recognize CeNET source connection. Water droplets may form on the internal lens. CD CeNET The microprocessor has not stored the proper CeNET information. The CeNET cable is not connected properly. Perform a system check. [. . . ]