User manual CLARION MCD360

[. . . ] The crossover frequency can be adjusted from 32Hz - 400Hz or from 640Hz - 8kHz with the crossover frequency multiplier switch. The crossover frequency can be adjusted from 32Hz - 400 Hz. The crossover frequency can be adjusted from 45Hz - 250 Hz. Example: If the frequency is set for 70Hz, moving the frequency multiplier switch to X20 changes the setting to 1. [. . . ] 2-Way System Application Notes After all the wiring connections are made and before the system is turned on for the first time, you need to make some basic adjustments. It is important that the High-Pass and Low-Pass Frequency Controls are set correctly before turning on the system for the first time. The following are some guidelines if this information is not available: · Most 3" speakers will not operate below 300Hz. ⷠMost subwoofers have decreased sound quality when operated above 150Hz. Depending upon the size of the front and rear speakers and the type of subwoofer system, fine tuning these adjustments may be required after the initial system set-up. Study the system design pages of this manual to determine the proper settings for these controls. Speakers are easily damaged if they are crossed over at a frequency below their usable range. When making the high frequency adjustments, adjust the Low-Pass frequency control and the low frequency amplifier gain. Usually, the LowPass frequency should be set the same as the High-Pass frequency. NOTE: An exception will be when the front/rearspeakeris too small to play down to a very low frequency and the subwoofersounds distorted trying to "play up" to meet the front/rearspeaker. This may require a gap ordifference between the high and low settings. Although not ideal, this is sometimes necessary to make the system work as well as possible. Setting the Front Output Level Before setting front level controls, disconnect both the rear output and the subwoofer output and follow the directions below. Turn the output control level to the minimum setting. Turn the source unit on and increase the volume until distortion is heard, then reduce volume to just below this point. nOTE: This is the maximum usable musical signal forthis source unit. Turning the volume beyond this point will increase noise and distortion without an increase in musical signal. If you can increase the source unit volume to maximum without audible disortion, raise the output level controls slightly and begin again. With the amplifier gains still at minimum and the source unit set at maximum volume without distortion, raise the front output level control until distortion is heard, then reduce gain to just below this point. This is the maximum output level for this system. For best performance do not increase beyond this point. Setting the Rear Output Level Before setting rear level controls, disconnect both the front output and the subwoofer output and follow the directions below. [. . . ] Turn the source unit on and increase the volume until distortion is heard, then reduce volume to just below this point. nOTE: This is the maximum usable musical signal forthis source unit. Turning the volume beyond this point will increase noise and distortion without an increase in musical signal. If you can increase the source unit volume to maximum without audible disortion, raise the output level controls slightly and begin again. [. . . ]