User manual CLARION MS2100

[. . . ] The remote transmitter still can be used to arm the system in Passive Arming mode. This is a programmable feature that can be selected at the time of installation. Exit the vehicle and close all the doors. · The LED will begin to flash rapidly to indicate the alarm system is preparing to arm. [. . . ] However, the optional keyless entry and auxiliary outputs will still function if installed. Press and hold the Valet/Override button. Continue holding the Valet/Override button for 3 seconds. · The LED will turn On solid indicating the system is in Valet mode. Press and hold the Valet/Override button down. Hold the Valet/Override button for 3 seconds. · The LED will turn off indicating the system is out of Valet mode. 2. 11 Optional Trunk Release Press the Trunk button for approximately 3 seconds to open the trunk. * * May require additional parts and labor. 2. 12 Optional Trunk Disarm Feature (Programmable feature) The trunk disarm feature allows the alarm to disarm automatically when the Trunk button is used to activate the optional trunk release. This eliminates having to disarm the alarm system prior to activating the trunk release. 2. 13 Remote Sensor Bypass To arm the system and bypass the shock sensor, hood/trunk inputs, press the Lock button to Arm, then within 2 seconds press the Lock button again. The siren will chirp 5 times to indicate Sensor Bypass mode. 2. 14 Programming Remote Transmitters Prior to programming new remote transmitters to the security system, make sure to have the desired transmitters ready. 2. 15 To Enter Remote Transmitter Programming 1. Turn the ignition ON, OFF, ON, OFF, and leave ON. Press and hold the Valet/Override switch for 5 seconds. Press the Lock button on the transmitter. Press the Lock button on the transmitter again. Repeat steps 3 and 4 for each additional transmitter. Turn OFF the ignition when transmitter programming is complete. 5 2. 16 Transmitter Operation BUTTON Lock Unlock Trunk Lock Lock then Lock DURATION Short Short Long (3 Seconds) Long (3 Seconds) Short then Short FUNCTION Arm Disarm Auxiliary 1 Output Panic Remote Sensor Bypass 2. 17 Status Indicator (LED) Functions LED STATUS Off Slow Flash Rapid Flash Rapid Flash (after disarm) On Solid On Solid (after arming) On Solid (when disarmed and not in Valet mode) FUNCTION System is disarmed in Active mode System is Armed Passive arming indication and auto rearm System was triggered Valet mode On for 10 seconds, shock sensor trigger has not yet armed Door or hood/trunk is open 6 2. 18 Siren Chirp Status CHIRPS 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Rapid Chirps 2 Chirps when the ignition is turned Off. FUNCTION System Armed System Disarmed System Disarmed, but alarm was triggered while away. [. . . ] Clarion Corporation will not assume any responsibility for any loss or damage incurred in shipping. ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES SHALL CLARION CORPORATION BE LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTIAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. [. . . ]