User manual CLARION OHM102

[. . . ] Warning! The Clarion OHM102/OHM153 overhead monitor systems are designed for strictly for rear seat entertainment. Viewing the monitor while operating a motor vehicle can result in serious injury and/or property damage. Clarion is not responsible for any injury and/or property damage as a result of the improper use or viewing of the monitor. Welcome! Thank you for purchasing the Clarion OHM102/OHM153 overhead monitor system. These monitors are engineered with advanced technological designs and components for the best picture quality and convenience. [. . . ] Each time the MODE button is pressed, the screen mode switches in the following sequence: Note: The screen mode will set after 5 seconds, pending that the MODE button is not pressed. The display image may appear coarse or grainy when viewed in Zoom mode. Changing the Display Settings (Picture In Picture/Split Screen) The display setting can be adjusted by pressing the PIP (Picture In Picture) button on the control panel or remote control. This button selects between PIP and split screen viewing mode. In PIP mode, the second image can be displayed in any of the four corners and in four different viewing aspects. In split screen mode, the display is evenly divided between two AV sources. To access PIP or split screen display setting, press the PIP button until the desired mode is displayed. The screen will change in the following sequence: Selecting the AV Sources for Main and Sub Screen MAIN SCREEN Press the (DOWN Button) to select the desired AV source. The sources will be changed in following sequence: SUB SCREEN Press the (UP button) to select the desired AV source. The sources will be changed in following sequence: NOTE: Same video input cannot be viewed simultaneously. Dimmer Button: Press the DIMMER button to adjust the brightness of the screen. The brightness will change in the following sequence: OPERATING THE REMOTE CONTROL 1. Power button Press the Power button to turn ON/OFF the monitor. FM button Press to turn ON/OFF the FM modulator (FM200 not included) 3. DIMMER button Press to adjust the brightness of the screen. MENU button Press the MENU button to access the monitor adjustments. FM MOD ON/OFF>Brightness>Contrast>Saturation>Hue>Sub Size>Sub Position> Default Reset (Down button) MENU, then DOWN selects item to be adjusted. (Up button) MENU, then UP selects item to be adjusted. MAIN MODE button Press to change the screen format: Normal, Full, Zoom, and Wide. INPUT button Press to select AV source for Main Screen. PIP button Press to select PIP (Picture In Picture) or split screen operation. SWAP button Switches the PIP (Picture In Picture) with the Sub image. SUB POS button Press to select the location of the PIP (Picture In Picture) image. SIZE button Press to select the size of the PIP (Picture In Picture) image. INPUT button Press to select AV source for Sub Screen. [. . . ] 5 degrees C to 40 degrees C (41 degrees F to 104 degrees F. ). If the temperature is outside this operating range, the unit will turn on, or the screen may be slow to react to image changes. The monitor will function normally once it returns to its proper operating temperature range. With a DVD player and a widescreen DVD disc, there are black bars on the screen. [. . . ]