User manual CLARION OHM641

[. . . ] Do not install anywhere that would permit monitor to be viewed by the driver. Monitor must not be located in the motor vehicle at any point forward of the back of the front seats. Monitor must never be used in any manner that will distract driver or interfere with driver's safe operation of the motor vehicle. Be careful not to run down the car battery while using the set with the car stopped. [. . . ] The recommended viewing angle of the unit is ­ 30 to +10 degrees vertical and +45 to ­45 degrees horizontal. 5 APPLICATIONS With the VDH9600, TTX001 and the FM100S 1. Typically the tuner will be located close to the VCP or DVD player. Avoid areas with excessive heat or moisture and mount the tuner. Mount the TV antenna (ZCB-303 or equivalent) and plug into the tuner. Plug the 16 pin to A/V out connector into the tuner. Plug the A/V RCA cables, IR extension and power plug into the 16 pin connector and run to the video player. Plug the A/V RCA cable into the A/V input of the player. Plug the Y connector into the player and plug the IR extension into the Y connector. At the OHM641, plug the IR extension and power cables supplied with the OHM641. Run these cables to the back of the video player. Plug the video RCA into the video output of the player. Plug the IR extension into the other leg of the Y connector. These wires will be run to the radio location. Plug the audio RCA cable into the audio output of the player and run the audio RCA and main power cables to the radio location. Remove the radio and plug the audio RCA into the FM100S audio inputs. Mount the switch for the FM100S and run its power wire to the radio location. The power and ground wires of the TTX001, video player, OHM641 and the FM100S can be joined and connected to the radio accessory and ground wires. Plug the vehicle antenna into the antenna input of the FM100S. Plug the antenna output of the FM100S into the radio. The FM 100S has a two position switch to select the modulation frequency. Pick the frequency that has the least amount of radio reception and set that frequency on the modulator and into a radio preset memory. Operation Similar to a home system, the VDH9600 allow their auxiliary A/V inputs to loop through to their A/V outputs when they are not playing a video tape. · Because the IR lines have been linked together, each component can be controlled by its respective remote control when pointed to the IR eye located on OHM641. [. . . ] Solution: · The brightness is adjusted too low. Check that the brightness is properly adjusted and set it properly. This may happen if the temperature in the vehicle is below 30 degrees F or above 113 degrees F. Check again when the temperature is between 30 and 113 degrees F. 10 Problem: The power was turned off when driving on bumpy roads. [. . . ]